Re: [RFC PATCH v3 08/31] KVM: selftests: Require GCC to realign stacks on function entry

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 15.02.2023 01:50, Ackerley Tng wrote:

On Mon, Jan 23, 2023, Erdem Aktas wrote:
> On Mon, Jan 23, 2023 at 10:53 AM Sean Christopherson <seanjc@xxxxxxxxxx> wrote:
> >
> > On Mon, Jan 23, 2023, Maciej S. Szmigiero wrote:
> > > On 23.01.2023 19:30, Erdem Aktas wrote:
> > > > On Fri, Jan 20, 2023 at 4:28 PM Sean Christopherson <seanjc@xxxxxxxxxx> wrote:
> > > > >
> > > > > On Sat, Jan 21, 2023, Ackerley Tng wrote:
> > > > > > Some SSE instructions assume a 16-byte aligned stack, and GCC compiles
> > > > > > assuming the stack is aligned:
> > > > > > https://gcc.gnu.org/bugzilla/show_bug.cgi?id=40838. This combination
> > > > > > results in a #GP in guests.
> > > > > >
> > > > > > Adding this compiler flag will generate an alternate prologue and
> > > > > > epilogue to realign the runtime stack, which makes selftest code
> > > > > > slower and bigger, but this is okay since we do not need selftest code
> > > > > > to be extremely performant.
> > > > >
> > > > > Huh, I had completely forgotten that this is why SSE is problematic.  I ran into
> > > > > this with the base UPM selftests and just disabled SSE.  /facepalm.
> > > > >
> > > > > We should figure out exactly what is causing a misaligned stack.  As you've noted,
> > > > > the x86-64 ABI requires a 16-byte aligned RSP.  Unless I'm misreading vm_arch_vcpu_add(),
> > > > > the starting stack should be page aligned, which means something is causing the
> > > > > stack to become unaligned at runtime.  I'd rather hunt down that something than
> > > > > paper over it by having the compiler force realignment.
> > > >
> > > > Is not it due to the 32bit execution part of the guest code at boot
> > > > time. Any push/pop of 32bit registers might make it a 16-byte
> > > > unaligned stack.
> > >
> > > 32-bit stack needs to be 16-byte aligned, too (at function call boundaries) -
> > > see [1] chapter 2.2.2 "The Stack Frame"
> >
> > And this showing up in the non-TDX selftests rules that out as the sole problem;
> > the selftests stuff 64-bit mode, i.e. don't have 32-bit boot code.
>
> Thanks Maciej and Sean for the clarification. I was suspecting the
> hand-coded assembly part that we have for TDX tests but  it being
> happening in the non-TDX selftests disproves it.

Not necessarily, it could be both.  Goofs in the handcoded assembly and PEBKAC
on my end :-)

I figured it out!

GCC assumes that the stack is 16-byte aligned **before** the call
instruction. Since call pushes rip to the stack, GCC will compile code
assuming that on entrance to the function, the stack is -8 from a
16-byte aligned address.

Since for TDs we do a ljmp to guest code, providing a function's
address, the stack was not modified by a call instruction pushing rip to
the stack, so the stack is 16-byte aligned when the guest code starts
running, instead of 16-byte aligned -8 that GCC expects.

For VMs, we set rip to a function pointer, and the VM starts running
with a 16-byte algined stack too.

To fix this, I propose that in vm_arch_vcpu_add(), we align the
allocated stack address and then subtract 8 from that:


Note that if this code is ever used to launch a vCPU with 32-bit entry
point it will need to subtract 4 bytes instead of 8 bytes.

I think it would be worthwhile to at least place a comment mentioning
this near the stack aligning expression so nobody misses this fact.

Thanks,
Maciej




[Index of Archives]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Share Photos]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux