On 21.07.19 23:05, Christophe JAILLET wrote:
There is a typo in KTD2962_MM_MIN_CURR_THRESHOLD_SCALE. 6 and 9 are
switched in 2962.
Define and use KTD2692_MM_MIN_CURR_THRESHOLD_SCALE instead.
Signed-off-by: Christophe JAILLET <christophe.jaillet@xxxxxxxxxx>
---
drivers/leds/leds-ktd2692.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/leds/leds-ktd2692.c b/drivers/leds/leds-ktd2692.c
index 45296aaca9da..44db748c570e 100644
--- a/drivers/leds/leds-ktd2692.c
+++ b/drivers/leds/leds-ktd2692.c
@@ -22,7 +22,7 @@
/* Value related the movie mode */
#define KTD2692_MOVIE_MODE_CURRENT_LEVELS 16
#define KTD2692_MM_TO_FL_RATIO(x) ((x) / 3)
-#define KTD2962_MM_MIN_CURR_THRESHOLD_SCALE 8
+#define KTD2692_MM_MIN_CURR_THRESHOLD_SCALE 8
/* Value related the flash mode */
#define KTD2692_FLASH_MODE_TIMEOUT_LEVELS 8
@@ -253,7 +253,7 @@ static void ktd2692_setup(struct ktd2692_context *led)
ktd2692_expresswire_reset(led);
gpiod_direction_output(led->aux_gpio, KTD2692_LOW);
- ktd2692_expresswire_write(led, (KTD2962_MM_MIN_CURR_THRESHOLD_SCALE - 1)
+ ktd2692_expresswire_write(led, (KTD2692_MM_MIN_CURR_THRESHOLD_SCALE - 1)
| KTD2692_REG_MM_MIN_CURR_THRESHOLD_BASE);
ktd2692_expresswire_write(led, KTD2692_FLASH_MODE_CURR_PERCENT(45)
| KTD2692_REG_FLASH_CURRENT_BASE);
Reviewed-By: Enrico Weigelt <info@xxxxxxxxx>
--
Enrico Weigelt, metux IT consult
Free software and Linux embedded engineering
info@xxxxxxxxx -- +49-151-27565287
