Add a settings module-parameter which can be allowed to specify/override
various device-properties.
Usuually Goodix touchscreens on x86 devices (where there is no devicetree
to specify the properties) just work. But in some cases the touchscreen is
mounted 90 or 180 degrees rotated vs the display, requiring setting the
touchscreen-x/y-inverted or touchscreen-swapped-x-y properties.
Being able to specify the necessary properties through a module parameter,
allows users of new device-models to help us with bringing up support for
new devices without them needing to do a local kernel-build just to modify
these settings.
Reviewed-by: Bastien Nocera <hadess@xxxxxxxxxx>
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
drivers/input/touchscreen/goodix.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/input/touchscreen/goodix.c b/drivers/input/touchscreen/goodix.c
index c281e49826c2..36873f053f63 100644
--- a/drivers/input/touchscreen/goodix.c
+++ b/drivers/input/touchscreen/goodix.c
@@ -53,6 +53,10 @@
#define ACPI_GPIO_SUPPORT
#endif
+static char *settings;
+module_param(settings, charp, 0444);
+MODULE_PARM_DESC(settings, "Override touchscreen settings using a ; separated key=value list, e.g. \"touchscreen-fuzz-x=5;touchscreen-fuzz-y=5;touchscreen-swapped-x-y\"");
+
struct goodix_chip_id {
const char *id;
const struct goodix_chip_data *data;
@@ -1163,7 +1167,8 @@ static int goodix_configure_dev(struct goodix_ts_data *ts)
goodix_read_config(ts);
/* Try overriding touchscreen parameters via device properties */
- touchscreen_parse_properties(ts->input_dev, true, &ts->prop);
+ touchscreen_parse_properties_with_settings(ts->input_dev, true,
+ &ts->prop, settings);
if (!ts->prop.max_x || !ts->prop.max_y || !ts->max_touch_num) {
if (!ts->reset_controller_at_probe &&
--
2.37.3
