On Mon, Nov 14, 2016 at 02:11:14PM +0100, Hans de Goede wrote:
> commit ef3714fdbc8d ("Input: bma150 - extend chip detection for bma180"),
> adds bma180 chip-ids to the input bma150 driver, assuming that they are
> 100% compatible, but the bma180 is not compatible with the bma150 at all,
> it has 14 bits resolution instead of 10, and it has quite different
> control registers too.
>
> Treating the bma180 as a bma150 wrt its data registers will just result
> in throwing away the lowest 4 bits, which is not too bad. But the ctrl
> registers are a different story. Things happen to just work but supporting
> that certainly does not make treating the bma180 the same as the bma150
> right.
>
> Since some setups depend on the evdev interface the bma150 driver offers
> on top of the bma180, we cannot simply remove the bma180 ids.
>
> So this commit only removes the bma180 id when the bma180 iio driver,
> which does treat the bma180 properly, is enabled.
>
> Cc: Dr. H. Nikolaus Schaller <hns@xxxxxxxxxxxxx>
> Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
Applied, thank you.
> ---
> Changes in v2:
> -Use IS_ENABLED(CONFIG_BMA180) instead of #ifdef CONFIG_BMA180
> ---
> drivers/input/misc/bma150.c | 9 ++++++++-
> 1 file changed, 8 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/input/misc/bma150.c b/drivers/input/misc/bma150.c
> index b0d4453..2124390 100644
> --- a/drivers/input/misc/bma150.c
> +++ b/drivers/input/misc/bma150.c
> @@ -538,8 +538,13 @@ static int bma150_probe(struct i2c_client *client,
> return -EIO;
> }
>
> + /*
> + * Note if the IIO CONFIG_BMA180 driver is enabled we want to fail
> + * the probe for the bma180 as the iio driver is preferred.
> + */
> chip_id = i2c_smbus_read_byte_data(client, BMA150_CHIP_ID_REG);
> - if (chip_id != BMA150_CHIP_ID && chip_id != BMA180_CHIP_ID) {
> + if (chip_id != BMA150_CHIP_ID &&
> + (IS_ENABLED(CONFIG_BMA180) || chip_id != BMA180_CHIP_ID)) {
> dev_err(&client->dev, "BMA150 chip id error: %d\n", chip_id);
> return -EINVAL;
> }
> @@ -643,7 +648,9 @@ static UNIVERSAL_DEV_PM_OPS(bma150_pm, bma150_suspend, bma150_resume, NULL);
>
> static const struct i2c_device_id bma150_id[] = {
> { "bma150", 0 },
> +#if !IS_ENABLED(CONFIG_BMA180)
> { "bma180", 0 },
> +#endif
> { "smb380", 0 },
> { "bma023", 0 },
> { }
> --
> 2.9.3
>
--
Dmitry
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
