Shawn Guo wrote:
On Wed, Aug 15, 2012 at 06:31:48PM +0800, Hui Wang wrote:i.MX6Q sabrelite board uses i2c3 to connect an eeti egalax touchscreen controller, add it as an i2c slave device in the dts. Signed-off-by: Hui Wang <jason77.wang@xxxxxxxxx> --- arch/arm/boot/dts/imx6q-sabrelite.dts | 16 ++++++++++++++++ arch/arm/boot/dts/imx6q.dtsi | 7 +++++++ 2 files changed, 23 insertions(+), 0 deletions(-) diff --git a/arch/arm/boot/dts/imx6q-sabrelite.dts b/arch/arm/boot/dts/imx6q-sabrelite.dts index 72f30f3..4a68e1f 100644 --- a/arch/arm/boot/dts/imx6q-sabrelite.dts +++ b/arch/arm/boot/dts/imx6q-sabrelite.dts @@ -54,6 +54,7 @@ 144 0x80000000 /* MX6Q_PAD_EIM_D22__GPIO_3_22 */ 121 0x80000000 /* MX6Q_PAD_EIM_D19__GPIO_3_19 */ 953 0x80000000 /* MX6Q_PAD_GPIO_0__CCM_CLKO */ + 972 0x10 /* MX6Q_PAD_GPIO_9__GPIO_1_9 */ >; }; }; @@ -115,6 +116,21 @@ VDDIO-supply = <®_3p3v>; }; }; + + i2c@021a8000 { /* I2C3 */ + status = "okay"; + clock-frequency = <100000>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_i2c3_1>; + + egalax_ts@04 { + compatible = "eeti,egalax_ts"; + reg = <0x04>; + interrupt-parent = <&gpio1>; + interrupts = <9 2>;So you take this interrupt as falling-edge, while I see IRQF_TRIGGER_LOW is used in driver with request_threaded_irq call. Regards, Shawn
Yes, you are right. Should be 8 instead of 2. Regards, Hui. -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
