On Mon, 17 Mar 2025 18:56:21 +0100, Sergio Perez wrote: > Some BH1750 sensors require a hardware reset before they can be > detected on the I2C bus. This patch adds support for an optional > reset GPIO that can be specified in the device tree. > > The reset sequence pulls the GPIO low and then high before > initializing the sensor, which enables proper detection with > tools like i2cdetect. > > Signed-off-by: Sergio Perez <sergio@xxxxxxxxxxx> > --- > .../devicetree/bindings/iio/light/bh1750.yaml | 7 +++++- > drivers/iio/light/bh1750.c | 24 ++++++++++++++++++- > 2 files changed, 29 insertions(+), 2 deletions(-) > My bot found errors running 'make dt_binding_check' on your patch: yamllint warnings/errors: ./Documentation/devicetree/bindings/iio/light/bh1750.yaml:50:4: [error] no new line character at the end of file (new-line-at-end-of-file) dtschema/dtc warnings/errors: Error: Documentation/devicetree/bindings/iio/light/bh1750.example.dts:25.38-39 syntax error FATAL ERROR: Unable to parse input tree make[2]: *** [scripts/Makefile.dtbs:131: Documentation/devicetree/bindings/iio/light/bh1750.example.dtb] Error 1 make[2]: *** Waiting for unfinished jobs.... make[1]: *** [/builds/robherring/dt-review-ci/linux/Makefile:1522: dt_binding_check] Error 2 make: *** [Makefile:248: __sub-make] Error 2 doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20250317175621.593-1-sergio@xxxxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
