When a weak pull-up is present on the SDO line, regmap_update_bits fails
to write both the SOFTRESET and SDOACTIVE bits because it incorrectly
reads them as already set.
Since the soft reset disables the SDO line, performing a
read-modify-write operation on ADI_SPI_CONFIG_A to enable the SDO line
doesn't make sense. This change directly writes to the register instead
of using regmap_update_bits.
Fixes: f34fe888ad05 ("iio:filter:admv8818: add support for ADMV8818")
Signed-off-by: Sam Winchenbach <swinchenbach@xxxxxxxx>
---
drivers/iio/filter/admv8818.c | 14 ++++----------
1 file changed, 4 insertions(+), 10 deletions(-)
diff --git a/drivers/iio/filter/admv8818.c b/drivers/iio/filter/admv8818.c
index 195e58bc4..9cd1eee84 100644
--- a/drivers/iio/filter/admv8818.c
+++ b/drivers/iio/filter/admv8818.c
@@ -577,21 +577,15 @@ static int admv8818_init(struct admv8818_state *st)
struct spi_device *spi = st->spi;
unsigned int chip_id;
- ret = regmap_update_bits(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
- ADMV8818_SOFTRESET_N_MSK |
- ADMV8818_SOFTRESET_MSK,
- FIELD_PREP(ADMV8818_SOFTRESET_N_MSK, 1) |
- FIELD_PREP(ADMV8818_SOFTRESET_MSK, 1));
+ ret = regmap_write(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
+ ADMV8818_SOFTRESET_N_MSK | ADMV8818_SOFTRESET_MSK);
if (ret) {
dev_err(&spi->dev, "ADMV8818 Soft Reset failed.\n");
return ret;
}
- ret = regmap_update_bits(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
- ADMV8818_SDOACTIVE_N_MSK |
- ADMV8818_SDOACTIVE_MSK,
- FIELD_PREP(ADMV8818_SDOACTIVE_N_MSK, 1) |
- FIELD_PREP(ADMV8818_SDOACTIVE_MSK, 1));
+ ret = regmap_write(st->regmap, ADMV8818_REG_SPI_CONFIG_A,
+ ADMV8818_SDOACTIVE_N_MSK | ADMV8818_SDOACTIVE_MSK);
if (ret) {
dev_err(&spi->dev, "ADMV8818 SDO Enable failed.\n");
return ret;
--
2.48.1
