The BMP{2,3,5}80 and BME280 devices have an SPI interface, so include it in the device-tree. Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> Signed-off-by: Vasileios Amoiridis <vassilisamir@xxxxxxxxx> --- .../bindings/iio/pressure/bmp085.yaml | 32 +++++++++++++++++++ 1 file changed, 32 insertions(+) diff --git a/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml b/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml index cb201cecfa1a..43af400a9939 100644 --- a/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml +++ b/Documentation/devicetree/bindings/iio/pressure/bmp085.yaml @@ -55,12 +55,16 @@ properties: If not set, defaults to push-pull configuration. type: boolean + spi-max-frequency: + maximum: 10000000 + required: - compatible - vddd-supply - vdda-supply allOf: + - $ref: /schemas/spi/spi-peripheral-props.yaml# - if: properties: compatible: @@ -73,6 +77,16 @@ allOf: then: properties: interrupts: false + - if: + properties: + compatible: + contains: + enum: + - bosch,bmp085 + - bosch,bmp180 + then: + properties: + spi-max-frequency: false additionalProperties: false @@ -93,3 +107,21 @@ examples: vdda-supply = <&bar>; }; }; + - | + # include <dt-bindings/gpio/gpio.h> + # include <dt-bindings/interrupt-controller/irq.h> + spi { + #address-cells = <1>; + #size-cells = <0>; + pressure@0 { + compatible = "bosch,bmp280"; + reg = <0>; + spi-max-frequency = <10000000>; + interrupt-parent = <&gpio0>; + interrupts = <25 IRQ_TYPE_EDGE_RISING>; + reset-gpios = <&gpio0 26 GPIO_ACTIVE_LOW>; + vddd-supply = <&foo>; + vdda-supply = <&bar>; + }; + }; + -- 2.43.0