On Mon, 07 Oct 2024 15:14:39 +0200, Neil Armstrong wrote: > Document the bindings for the Allegro MicroSystems ALS31300 3-D Linear Hall > Effect Sensor controller by an I2C interface, mainly used in 3D head-on > motion sensing applications. > > The device can be configured with different sensitivities in factory, > but the sensitivity value used to calculate value into the Gauss > unit is not available from registers, thus the sensitivity is > provided by the compatible/device-id string which is based > on the part number as described in the datasheet page 2. > > The datasheet is available on the product website at [1]. > > [1] https://www.allegromicro.com/en/products/sense/linear-and-angular-position/linear-position-sensor-ics/als31300 > > Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx> > --- > .../iio/magnetometer/allegro,als31300.yaml | 43 ++++++++++++++++++++++ > 1 file changed, 43 insertions(+) > My bot found errors running 'make dt_binding_check' on your patch: yamllint warnings/errors: dtschema/dtc warnings/errors: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/iio/magnetometer/allegro,als31300.yaml: $id: Cannot determine base path from $id, relative path/filename doesn't match actual path or filename $id: http://devicetree.org/schemas/iio/magnetometer/allegromicro,als31300.yaml file: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/iio/magnetometer/allegro,als31300.yaml Documentation/devicetree/bindings/iio/magnetometer/allegro,als31300.example.dtb: /example-0/i2c/sensor@61: failed to match any schema with compatible: ['allegromicro,als31300'] doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20241007-topic-input-upstream-als31300-v1-2-2c240ea5cb77@xxxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
