This patch series adds support for Texas Instruments OPT4060 RGBW Color sensor using the i2c interface. The driver exposes both raw adc values and calculated lux values though sysfs. Integration time can be configured though sysfs as well. The OPT4060 sensor supports both rising and falling threshold interrupts. These interrupts are exposed as IIO events. The driver also implements an IIO triggered buffer with two triggers, one trigger for conversion ready interrupts and one trigger for threshold interrupts. The typical use case for this is to define a threshold and listen for the events, and at the same time enable the triggered buffer with the threshold trigger. Once the application gets the threshold event, the values from the time of the event will be available in the triggered buffer. This limits the number of interrupts between sensor and host and also the the usage of sysfs for reading values after events. Changes in v2: - dt-bindings: Removed incorrect allOf. - dt-bindings: Changed to generic node name. - Correction in opt4060_trigger_one_shot(...) for continuous mode. - Correction in opt4060_power_down(...), wrong register was read. - Corrected usage of active_scan_mask in opt4060_trigger_handler(...). - Clean-up of various comments. - Link to V1: https://lore.kernel.org/lkml/20241003164932.1162049-1-perdaniel.olsson@xxxxxxxx/ Per-Daniel Olsson (2): dt-bindings: iio: light: Document TI OPT4060 RGBW sensor iio: light: Add support for TI OPT4060 color sensor .../bindings/iio/light/ti,opt4060.yaml | 51 + drivers/iio/light/Kconfig | 13 + drivers/iio/light/Makefile | 1 + drivers/iio/light/opt4060.c | 1216 +++++++++++++++++ 4 files changed, 1281 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/light/ti,opt4060.yaml create mode 100644 drivers/iio/light/opt4060.c base-commit: 0c559323bbaabee7346c12e74b497e283aaafef5 -- 2.39.5
