Update the interrupt configuration to use the INT2 pin for
the dataready interrupt.
Address the FIXME: support using the INT2 pin.
Signed-off-by: Abhishek Tamboli <abhishektamboli9@xxxxxxxxx>
---
drivers/iio/accel/bma180.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/iio/accel/bma180.c b/drivers/iio/accel/bma180.c
index 6581772cb0c4..d44409afffbf 100644
--- a/drivers/iio/accel/bma180.c
+++ b/drivers/iio/accel/bma180.c
@@ -126,7 +126,7 @@ struct bma180_part_info {
#define BMA250_SUSPEND_MASK BIT(7) /* chip will sleep */
#define BMA250_LOWPOWER_MASK BIT(6)
#define BMA250_DATA_INTEN_MASK BIT(4)
-#define BMA250_INT1_DATA_MASK BIT(0)
+#define BMA250_INT2_DATA_MASK BIT(7)
#define BMA250_INT_RESET_MASK BIT(7) /* Reset pending interrupts */
struct bma180_data {
@@ -425,10 +425,9 @@ static int bma250_chip_config(struct bma180_data *data)
if (ret)
goto err;
/*
- * This enables dataready interrupt on the INT1 pin
- * FIXME: support using the INT2 pin
+ * This enables dataready interrupt on the INT2 pin
*/
- ret = bma180_set_bits(data, BMA250_INT_MAP_REG, BMA250_INT1_DATA_MASK, 1);
+ ret = bma180_set_bits(data, BMA250_INT_MAP_REG, BMA250_INT2_DATA_MASK, 1);
if (ret)
goto err;
--
2.34.1
