The following changes since commit 6613476e225e090cc9aad49be7fa504e290dd33d: Linux 6.8-rc1 (2024-01-21 14:11:32 -0800) are available in the Git repository at: https://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio.git tags/iio-fixes-for-6.8a for you to fetch changes up to 78367c32bebfe833cd30c855755d863a4ff3fdee: iio: adc: ad4130: only set GPIO_CTRL if pin is unused (2024-02-10 16:52:39 +0000) ---------------------------------------------------------------- IIO: 1st set of fixes for the 6.8 cycle Usual mixed bag of issues introduced this cycle and fixes for long term issues that have been identified recently + one case where I messed up a merge resolution and dropped the build file changes. Most important is the userspace ABI fix for the iio_modifier enum where we accidentally added new entries in the middle rather than at the end. IIO Core - Close a memory leak in an error path. - Move LIGHT_UVA and LIGHT_UVB definitions to end of the iio_modifier enum to avoid breaking older userspace. (not yet in a released kernel thankfully). adi,adis - Fix a DMA buffer alignment issue that was missing in series that fixed these across IIO. adi,ad-sigma-delta - Fix a DMA buffer alignment issue that was missing in series that fixed these across IIO. adi,ad4130 - Zero init remaining fields of clock init data. - Only set GPIO control bits on pins that aren't in use for anything else. adi,ad5933 - Fix an old bug due to type mismatch. This is a rare device so good to get some new test coverage. adi,ad7091r - Use right variable for an error return code. bosch,bma400 - Add missing CONFIG_REGMAP_I2C dependency. bosch,bmp280: - Add missing bmp085 ID to the SPI table to avoid mismatch with the of_device_id table. hid-sensors: - Avoid returning an error for timestamp read back that succeeds. pni,rm3100 - Check value read from RM31000_REG_TMRC register is valid before using it. Hardening to avoid a real world issue seen on some faulty hardware. st,st-sensors - Fix a DMA buffer alignment issue that was missing in series that fixed these across IIO. ti,hdc3020 - Add missing Kconfig and Makefile entrees accidentally dropped when patches were applied. - Fix wrong temperature offset (negated) ---------------------------------------------------------------- Cosmin Tanislav (2): iio: adc: ad4130: zero-initialize clock init data iio: adc: ad4130: only set GPIO_CTRL if pin is unused Dan Carpenter (1): iio: adc: ad7091r8: Fix error code in ad7091r8_gpio_setup() David Schiller (1): staging: iio: ad5933: fix type mismatch regression Dimitri Fedrau (1): iio: humidity: hdc3020: fix temperature offset Dinghao Liu (1): iio: core: fix memleak in iio_device_register_sysfs Javier Carrasco (1): iio: move LIGHT_UVA and LIGHT_UVB to the end of iio_modifier Jonathan Cameron (1): iio: humidity: hdc3020: Add Makefile, Kconfig and MAINTAINERS entry Mario Limonciello (1): iio: accel: bma400: Fix a compilation problem Nuno Sa (3): iio: imu: adis: ensure proper DMA alignment iio: adc: ad_sigma_delta: ensure proper DMA alignment iio: commom: st_sensors: ensure proper DMA alignment Randy Dunlap (1): iio: imu: bno055: serdev requires REGMAP Sam Protsenko (1): iio: pressure: bmp280: Add missing bmp085 to SPI id table Srinivas Pandruvada (1): iio: hid-sensor-als: Return 0 for HID_USAGE_SENSOR_TIME_TIMESTAMP zhili.liu (1): iio: magnetometer: rm3100: add boundary check for the value read from RM3100_REG_TMRC MAINTAINERS | 8 ++++++++ drivers/iio/accel/Kconfig | 2 ++ drivers/iio/adc/ad4130.c | 12 ++++++++---- drivers/iio/adc/ad7091r8.c | 2 +- drivers/iio/humidity/Kconfig | 12 ++++++++++++ drivers/iio/humidity/Makefile | 1 + drivers/iio/humidity/hdc3020.c | 2 +- drivers/iio/imu/bno055/Kconfig | 1 + drivers/iio/industrialio-core.c | 5 ++++- drivers/iio/light/hid-sensor-als.c | 1 + drivers/iio/magnetometer/rm3100-core.c | 10 ++++++++-- drivers/iio/pressure/bmp280-spi.c | 1 + drivers/staging/iio/impedance-analyzer/ad5933.c | 2 +- include/linux/iio/adc/ad_sigma_delta.h | 4 +++- include/linux/iio/common/st_sensors.h | 4 ++-- include/linux/iio/imu/adis.h | 3 ++- include/uapi/linux/iio/types.h | 4 ++-- 17 files changed, 58 insertions(+), 16 deletions(-)
