On Wed, 2024-02-07 at 15:20 +0200, Cosmin Tanislav wrote:
> Currently, GPIO_CTRL bits are set even if the pins are used for
> measurements.
>
> GPIO_CTRL bits should only be set if the pin is not used for
> other functionality.
>
> Fix this by only setting the GPIO_CTRL bits if the pin has no
> other function.
>
> Fixes: 62094060cf3a ("iio: adc: ad4130: add AD4130 driver")
> Signed-off-by: Cosmin Tanislav <demonsingur@xxxxxxxxx>
> ---
Reviewed-by: Nuno Sa <nuno.sa@xxxxxxxxxx>
> drivers/iio/adc/ad4130.c | 10 +++++++---
> 1 file changed, 7 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/iio/adc/ad4130.c b/drivers/iio/adc/ad4130.c
> index c7df499f9775..febb64e67955 100644
> --- a/drivers/iio/adc/ad4130.c
> +++ b/drivers/iio/adc/ad4130.c
> @@ -1864,10 +1864,14 @@ static int ad4130_setup(struct iio_dev *indio_dev)
> return ret;
>
> /*
> - * Configure all GPIOs for output. If configured, the interrupt
> function
> - * of P2 takes priority over the GPIO out function.
> + * Configure unused GPIOs for output. If configured, the interrupt
> + * function of P2 takes priority over the GPIO out function.
> */
> - val = AD4130_IO_CONTROL_GPIO_CTRL_MASK;
> + val = 0;
> + for (i = 0; i < AD4130_MAX_GPIOS; i++)
> + if (st->pins_fn[i + AD4130_AIN2_P1] == AD4130_PIN_FN_NONE)
> + val |= FIELD_PREP(AD4130_IO_CONTROL_GPIO_CTRL_MASK,
> BIT(i));
> +
> val |= FIELD_PREP(AD4130_IO_CONTROL_INT_PIN_SEL_MASK, st-
> >int_pin_sel);
>
> ret = regmap_write(st->regmap, AD4130_IO_CONTROL_REG, val);
