> > + adi,mixer-mode:
> > + description:
> > + Enable mixer mode.
> > + type: boolean
> > +
> > + switch-gpios:
> > + description: |
> > + GPIOs to select the RF path for the channel.
> > + SW-CH1 CTRL-A CTRL-B
> > + SW-CH2 CTRL-A CTRL-B CH1 Status CH2 Status
> > + 1 0 Direct IF mode Mixer mode
> > + 0 1 Mixer mode Direct IF mode
>
> I cannot make sense of this table you have here, the double header row you
> have going on is hard to follow. There's also no mention here of what happens
> when both GPIOs are 0 or both GPIO are 1. Are these configurations permitted?
I also feel that it's quite hard to understand without the gridlines. In the preliminary
datasheet, it's a switch control table, and I'm trying to replicate the way it is presented.
On the table, each channel has control pins (CTRL-A and CTRL-B). For a mixer mode
configuration on channel 1, CTRL-A GPIO should be 0, and CTRL-B GPIO should be 1.
It's not permitted when both GPIOs are 0 or both GPIOs are 1. The state for the GPIO
should strictly follow the truth table.
I'm considering making it much easier to understand by creating two separate tables for
each channel, just like the example below. Or is it preferred if it could be discussed in
a sort of paragraph form?
SW-CH1 CTRL-A CTRL-B CH1 Status CH2 Status
1 0 Direct IF mode Mixer
SW-CH2 CTRL-A CTRL-B CH1 Status CH2 Status
0 1 Direct IF mode Mixer
Best regards,
Kim
