Re: [PATCH v4 15/15] iio: adc: ad7091r: Allow users to configure device events

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, 16 Dec 2023 14:51:50 -0300
Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx> wrote:

> Implement event configuration callbacks allowing users to read/write
> event thresholds and enable/disable event generation.
> 
> Signed-off-by: Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx>
> ---
> This is from a review suggestion David made on v3 [1].
> 
> Is this the case for a Suggested-by tag?
> 
> [1]: https://lore.kernel.org/linux-iio/CAMknhBFPbAqp4-AQdmbp+VRW-Ksk1PxaLCG+3n=Zk4gyStqhgw@xxxxxxxxxxxxxx/#t
> 
>  drivers/iio/adc/ad7091r-base.c | 117 +++++++++++++++++++++++++++++++--
>  1 file changed, 113 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/iio/adc/ad7091r-base.c b/drivers/iio/adc/ad7091r-base.c
> index 57355ca157a1..64e8baeff258 100644
> --- a/drivers/iio/adc/ad7091r-base.c
> +++ b/drivers/iio/adc/ad7091r-base.c
> @@ -20,19 +20,18 @@ const struct iio_event_spec ad7091r_events[] = {
>  	{
>  		.type = IIO_EV_TYPE_THRESH,
>  		.dir = IIO_EV_DIR_RISING,
> -		.mask_separate = BIT(IIO_EV_INFO_VALUE) |
> -				 BIT(IIO_EV_INFO_ENABLE),
> +		.mask_separate = BIT(IIO_EV_INFO_VALUE),

This is an ABI change.  So would need a really strong reason to make it...
mind you - it seems like this has been broken until now anyway so this change
may be fine.


>  	},
>  	{
>  		.type = IIO_EV_TYPE_THRESH,
>  		.dir = IIO_EV_DIR_FALLING,
> -		.mask_separate = BIT(IIO_EV_INFO_VALUE) |
> -				 BIT(IIO_EV_INFO_ENABLE),
> +		.mask_separate = BIT(IIO_EV_INFO_VALUE),
>  	},
>  	{
>  		.type = IIO_EV_TYPE_THRESH,
>  		.dir = IIO_EV_DIR_EITHER,
>  		.mask_separate = BIT(IIO_EV_INFO_HYSTERESIS),
> +		.mask_shared_by_all = BIT(IIO_EV_INFO_ENABLE),
It's relatively unusual that you can't separate the two event directions with careful
control of the thresholds.  So I think you can implement the existing ABI by
just setting the thresholds to the either 0 or 2^12 - 1 as appropriate.
The docs seem to say it must exceed the value, or fall below the min so these values
should ensure it can't do either.

You can then enable the event generate if one of them is set.






[Index of Archives]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Input]     [Linux Kernel]     [Linux SCSI]     [X.org]

  Powered by Linux