On Thu, 21 Sep 2023 09:43:47 -0500 David Lechner <dlechner@xxxxxxxxxxxx> wrote: > This removes the special handling for resolutions lower than 16 bits. > This will allow us to use a fixed scale independent of the resolution. > > Also, for the record, according to the datasheet, the logic for the > special handling based on hysteresis that was removed was incorrect. > > Signed-off-by: David Lechner <dlechner@xxxxxxxxxxxx> This looks fine to me, but a potential improvement would be to just use a __be16 element in st in the first place have the type explicitly marked all the way through. Jonathan > --- > drivers/staging/iio/resolver/ad2s1210.c | 16 ++-------------- > 1 file changed, 2 insertions(+), 14 deletions(-) > > diff --git a/drivers/staging/iio/resolver/ad2s1210.c b/drivers/staging/iio/resolver/ad2s1210.c > index 9c7f76114360..985b8fecd65a 100644 > --- a/drivers/staging/iio/resolver/ad2s1210.c > +++ b/drivers/staging/iio/resolver/ad2s1210.c > @@ -465,10 +465,7 @@ static int ad2s1210_read_raw(struct iio_dev *indio_dev, > long m) > { > struct ad2s1210_state *st = iio_priv(indio_dev); > - u16 negative; > int ret = 0; > - u16 pos; > - s16 vel; > > mutex_lock(&st->lock); > gpiod_set_value(st->gpios[AD2S1210_SAMPLE], 0); > @@ -494,20 +491,11 @@ static int ad2s1210_read_raw(struct iio_dev *indio_dev, > > switch (chan->type) { > case IIO_ANGL: > - pos = be16_to_cpup((__be16 *)st->rx); > - if (st->hysteresis) > - pos >>= 16 - st->resolution; > - *val = pos; > + *val = be16_to_cpup((__be16 *)st->rx); Could be made more obvious still by adding as suitable __be16 to read into in the first place. > ret = IIO_VAL_INT; > break; > case IIO_ANGL_VEL: > - vel = be16_to_cpup((__be16 *)st->rx); > - vel >>= 16 - st->resolution; > - if (vel & 0x8000) { > - negative = (0xffff >> st->resolution) << st->resolution; > - vel |= negative; > - } > - *val = vel; > + *val = (s16)be16_to_cpup((__be16 *)st->rx); > ret = IIO_VAL_INT; > break; > default: