On Mon, 22 May 2023 16:26:20 +0200
Astrid Rost <astrid.rost@xxxxxxxx> wrote:
> Add the proximity multi pulse (PS_MPS) as oversampling_ratio.
> Instead of one single pulse per every defined time frame,
> one can program 2, 4, or even 8 pulses. This leads to a
> longer IRED on-time for each proximity measurement value, which
> also results in a higher detection range.
>
> Add read/write attribute for proximity oversampling-ratio and read
> attribute for available oversampling-ratio.
> This is supported for vcnl4040 and vcnl4200.
>
> Signed-off-by: Astrid Rost <astrid.rost@xxxxxxxx>
I applied the series and did a build test which showed me...
> @@ -1648,6 +1729,9 @@ static const struct iio_chan_spec vcnl4040_channels[] = {
> .info_mask_separate = BIT(IIO_CHAN_INFO_RAW) |
> BIT(IIO_CHAN_INFO_INT_TIME),
> .info_mask_separate_available = BIT(IIO_CHAN_INFO_INT_TIME),
> + BIT(IIO_CHAN_INFO_OVERSAMPLING_RATIO),
> + .info_mask_separate_available = BIT(IIO_CHAN_INFO_INT_TIME) |
> + BIT(IIO_CHAN_INFO_OVERSAMPLING_RATIO),
Guessing a rebase went wrong?
I thought about just fixing this up by dropping the duplication, but given
I'm not 100% sure nothing else was affected, I'll leave it to you to fix up
and check for any other related issues for a v5.
Jonathan
> .ext_info = vcnl4000_ext_info,
> .event_spec = vcnl4040_event_spec,
> .num_event_specs = ARRAY_SIZE(vcnl4040_event_spec),
