Apparently, despite the name Digital Input Configuration Register, the
settings in the DIN_CONFIGx registers also affect other channel
functions. In particular, setting a non-zero value in the DIN_SINK
field breaks the resistance measurement function.
Now, one can of course argue that specifying a drive-strength-microamp
property along with a adi,ch-func which is not one of the digital
input functions is a bug in the device tree. However, we have a rather
complicated setup with instances of ad74412r on external hardware
modules, and have set a default drive-strength-microamp in our DT
fragments describing those, merely modifying the adi,ch-func settings
to reflect however the modules have been wired up. And restricting
this setting to just being done for digital input doesn't make the
driver any more complex.
Fixes: 504eb485589d1 (iio: ad74413r: wire up support for drive-strength-microamp property)
Signed-off-by: Rasmus Villemoes <linux@xxxxxxxxxxxxxxxxxx>
---
drivers/iio/addac/ad74413r.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/iio/addac/ad74413r.c b/drivers/iio/addac/ad74413r.c
index e3366cf5eb31..6b0e8218f150 100644
--- a/drivers/iio/addac/ad74413r.c
+++ b/drivers/iio/addac/ad74413r.c
@@ -1317,13 +1317,14 @@ static int ad74413r_setup_gpios(struct ad74413r_state *st)
}
if (config->func == CH_FUNC_DIGITAL_INPUT_LOGIC ||
- config->func == CH_FUNC_DIGITAL_INPUT_LOOP_POWER)
+ config->func == CH_FUNC_DIGITAL_INPUT_LOOP_POWER) {
st->comp_gpio_offsets[comp_gpio_i++] = i;
- strength = config->drive_strength;
- ret = ad74413r_set_comp_drive_strength(st, i, strength);
- if (ret)
- return ret;
+ strength = config->drive_strength;
+ ret = ad74413r_set_comp_drive_strength(st, i, strength);
+ if (ret)
+ return ret;
+ }
ret = ad74413r_set_gpo_config(st, i, gpo_config);
if (ret)
--
2.37.2
