IIO core correctly will take care of firmware node if it's not set in the driver. Drop ACPI and OF specifics from the driver and allow IIO core to handle this. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/iio/proximity/sx_common.c | 3 --- 1 file changed, 3 deletions(-) diff --git a/drivers/iio/proximity/sx_common.c b/drivers/iio/proximity/sx_common.c index 8ad814d96b7e..6bb68c1835da 100644 --- a/drivers/iio/proximity/sx_common.c +++ b/drivers/iio/proximity/sx_common.c @@ -5,7 +5,6 @@ * Common part of most Semtech SAR sensor. */ -#include <linux/acpi.h> #include <linux/bitops.h> #include <linux/byteorder/generic.h> #include <linux/delay.h> @@ -520,8 +519,6 @@ int sx_common_probe(struct i2c_client *client, if (ret) return dev_err_probe(dev, ret, "error reading WHOAMI\n"); - ACPI_COMPANION_SET(&indio_dev->dev, ACPI_COMPANION(dev)); - indio_dev->dev.of_node = client->dev.of_node; indio_dev->modes = INDIO_DIRECT_MODE; indio_dev->channels = data->chip_info->iio_channels; -- 2.35.1
