On 13/05/22 19:10, Shreeya Patel wrote:
On 13/05/22 05:24, Dmitry Osipenko wrote:
Hi Dmitry,
11.05.2022 12:40, Shreeya Patel пишет:
+static int ltrf216a_init(struct iio_dev *indio_dev)
+{
+ int ret;
+ struct ltrf216a_data *data = iio_priv(indio_dev);
+
+ ret = i2c_smbus_read_byte_data(data->client, LTRF216A_MAIN_CTRL);
+ if (ret < 0) {
+ dev_err(&data->client->dev, "Error reading
LTRF216A_MAIN_CTRL\n");
+ return ret;
+ }
+
+ /* enable sensor */
+ ret |= FIELD_PREP(LTRF216A_ALS_ENABLE_MASK, 1);
+ ret = i2c_smbus_write_byte_data(data->client,
LTRF216A_MAIN_CTRL, ret);
+ if (ret < 0) {
+ dev_err(&data->client->dev, "Error writing
LTRF216A_MAIN_CTRL\n");
+ return ret;
+ }
Couldn't you write "1" directly without reading?
What about doing SW reset?
I think we are doing a read here just to make sure device registers
are ready and accessible
without any issues.
I just came to know that in I2C communication, writing a single bit
requires reading the old value (whole byte),
modifying the result (i.e. set or clear the bit one is interested in)
and then write it back. So the above code writes
the enable bit without modifying the other bits in the
LTRF216A_MAIN_CTRL register. ( Thanks to Sebastian )
And you are right, we don't need to do a read here since we anyway want
all other bits of LTRF216A_MAIN_CTRL
to be 0.
Thanks,
Shreeya Patel
Also, why would we want to do a SW reset here?
In the datasheet, I could see the following steps to enable the sensor
Supply VDD to Sensor (Sensor in Standby Mode) ---> Wait 100 ms (min) -
initial startup time
---> I2C Command (Write) To enable sensor to Active Mode
Thanks,
Shreeya Patel
