From: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx>
The naming of the regulator is problematic. VCC is usually a supply
voltage whereas these devices have a separate VREF pin.
Secondly, the regulator core might have provided a stub regulator if
a real regulator wasn't provided. That would in turn have failed to
provide a voltage when queried. So reality was that there was no way
to use the internal reference.
In order to avoid breaking any dts out in the wild, make sure to fallback
to the original vcc naming if vref is not available.
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx>
---
drivers/iio/dac/ad5624r_spi.c | 18 +++++++++++++++++-
1 file changed, 17 insertions(+), 1 deletion(-)
diff --git a/drivers/iio/dac/ad5624r_spi.c b/drivers/iio/dac/ad5624r_spi.c
index 9bde86982912..b4888c8c14a2 100644
--- a/drivers/iio/dac/ad5624r_spi.c
+++ b/drivers/iio/dac/ad5624r_spi.c
@@ -229,7 +229,7 @@ static int ad5624r_probe(struct spi_device *spi)
if (!indio_dev)
return -ENOMEM;
st = iio_priv(indio_dev);
- st->reg = devm_regulator_get(&spi->dev, "vcc");
+ st->reg = devm_regulator_get_optional(&spi->dev, "vref");
if (!IS_ERR(st->reg)) {
ret = regulator_enable(st->reg);
if (ret)
@@ -240,6 +240,22 @@ static int ad5624r_probe(struct spi_device *spi)
goto error_disable_reg;
voltage_uv = ret;
+ } else {
+ if (PTR_ERR(st->reg) != -ENODEV) {
+ return PTR_ERR(st->reg);
+ /* Backwards compatibility. This naming is not correct */
+ st->reg = devm_regulator_get_optional(&spi->dev, "vcc");
+ if (!IS_ERR(st->reg)) {
+ ret = regulator_enable(st->reg);
+ if (ret)
+ return ret;
+
+ ret = regulator_get_voltage(st->reg);
+ if (ret < 0)
+ goto error_disable_reg;
+
+ voltage_uv = ret;
+ }
}
spi_set_drvdata(spi, indio_dev);
--
2.32.0
