On Thu, 3 Jun 2021 18:12:08 +0100 Jonathan Cameron <jic23@xxxxxxxxxx> wrote: > On Wed, 26 May 2021 14:12:02 +0200 > Linus Walleij <linus.walleij@xxxxxxxxxx> wrote: > > > On Wed, May 26, 2021 at 11:44 AM Stephan Gerhold <stephan@xxxxxxxxxxx> wrote: > > > > > According to the BMA253 datasheet [1] and BMA250 datasheet [2] the > > > bandwidth value for BMA25x should be set as 01xxx: > > > > > > "Settings 00xxx result in a bandwidth of 7.81 Hz; [...] > > > It is recommended [...] to use the range from ´01000b´ to ´01111b´ > > > only in order to be compatible with future products." > > > > > > However, at the moment the drivers sets bandwidth values from 0 to 6, > > > which is not recommended and always results into 7.81 Hz bandwidth > > > according to the datasheet. > > > > > > Fix this by introducing a bw_offset = 8 = 01000b for BMA25x, > > > so the additional bit is always set for BMA25x. > > > > > > [1]: https://www.bosch-sensortec.com/media/boschsensortec/downloads/datasheets/bst-bma253-ds000.pdf > > > [2]: https://datasheet.octopart.com/BMA250-Bosch-datasheet-15540103.pdf > > > > > > Cc: Peter Meerwald <pmeerw@xxxxxxxxxx> > > > Cc: Linus Walleij <linus.walleij@xxxxxxxxxx> > > > Fixes: 2017cff24cc0 ("iio:bma180: Add BMA250 chip support") > > > Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx> > > > > Good catch! > > Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx> > > Applied to the fixes-togreg branch of iio.git and marked for stable. > > I think I can probably get away with picking up patch 2 into the togreg branch > without anything blowing up during the merge. Change of plan here given dependency on this of another set and how late in the cycle we are. I've dragged this across from the fixes-togreg branch to the togreg branch lining it up for the next merge window. > > Thanks, > > Jonathan > > > > > > After spending some more time with the driver I noticed that BMA253/BMA254 > > > would actually be better supported by the bmc150-accel driver (which > > > doesn't have this problem and also supports the motion trigger/interrupt). > > > > > > I'm preparing a separate patch set to move BMA254 to bmc150-accel at least, > > > but I'm not sure about BMA250 so this patch is relevant anyway. And I had > > > it almost done already, so I thought it's better to send it. :) > > > > I looked at the preliminary patches and this looks really good > > too. > > > > Yours, > > Linus Walleij >
