From: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx> The call to pm_runtime_put_noidle() in remove() is not balancing a counter increment. Note this doesn't matter as the runtime pm core will not allow the counter to go negative. However, it is confusing to the reader so let's remove it. The pm_runtime_resume_and_get() replacement was found using coccicheck script under review at: https://lore.kernel.org/lkml/20210427141946.2478411-1-Julia.Lawall@xxxxxxxx/ This is a prequel to taking a closer look at the runtime pm in IIO drivers in general. Signed-off-by: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx> --- drivers/iio/adc/ti-ads1015.c | 5 +---- 1 file changed, 1 insertion(+), 4 deletions(-) diff --git a/drivers/iio/adc/ti-ads1015.c b/drivers/iio/adc/ti-ads1015.c index 5b828428be77..b0352e91ac16 100644 --- a/drivers/iio/adc/ti-ads1015.c +++ b/drivers/iio/adc/ti-ads1015.c @@ -323,9 +323,7 @@ static int ads1015_set_power_state(struct ads1015_data *data, bool on) struct device *dev = regmap_get_device(data->regmap); if (on) { - ret = pm_runtime_get_sync(dev); - if (ret < 0) - pm_runtime_put_noidle(dev); + ret = pm_runtime_resume_and_get(dev); } else { pm_runtime_mark_last_busy(dev); ret = pm_runtime_put_autosuspend(dev); @@ -1070,7 +1068,6 @@ static int ads1015_remove(struct i2c_client *client) pm_runtime_disable(&client->dev); pm_runtime_set_suspended(&client->dev); - pm_runtime_put_noidle(&client->dev); /* power down single shot mode */ return ads1015_set_conv_mode(data, ADS1015_SINGLESHOT); -- 2.31.1