On 7/1/20 4:55 PM, Fabrice Gasnier wrote:
> When the ADC is runtime suspended and starting a conversion, the stm32-adc
> driver calls pm_runtime_get_sync() that gets cascaded to the parent
> (e.g. runtime resume of stm32-adc-core driver). This also kicks the
> autosuspend delay (e.g. 2s) of the parent.
> Once the ADC is active, calling pm_runtime_get_sync() again (upon a new
> capture) won't kick the autosuspend delay for the parent (stm32-adc-core
> driver) as already active.
>
> Currently, this makes the stm32-adc-core driver go in suspend state
> every 2s when doing slow polling. As an example, doing a capture, e.g.
> cat in_voltageY_raw at a 0.2s rate, the auto suspend delay for the parent
> isn't refreshed. Once it expires, the parent immediately falls into
> runtime suspended state, in between two captures, as soon as the child
> driver falls into runtime suspend state:
> - e.g. after 2s, + child calls pm_runtime_put_autosuspend() + 100ms
> autosuspend delay of the child.
> - stm32-adc-core switches off regulators, clocks and so on.
> - They get switched on back again 100ms later in this example (at 2.2s).
>
> So, use runtime_idle() callback in stm32-adc-core driver to call
> pm_runtime_mark_last_busy() for the parent driver (stm32-adc-core),
> to avoid this.
>
> Fixes: 9bdbb1139ca1 ("iio: adc: stm32-adc: add power management support")
>
> Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxx>
> ---
> Changes in v2:
> - Use runtime_idle callback in stm32-adc-core driver, instead of refreshing
> last_busy from the child (for the parent) at many place. Initial patch v1
> looked like "somewhat adhoc solution" as commented by Jonathan.
Hi all,
Gentle reminder for this patch. Earlier discussions on it were as per
[1] and [2].
Ideally, Jonathan was looking for an ack from Rafael on this patch.
This is a long pending issue. I'd like to progress on this.
[1] https://patchwork.kernel.org/patch/11349841/
[2] https://lkml.org/lkml/2020/6/11/279
Please advise,
Thanks in advance,
Fabrice
> ---
> drivers/iio/adc/stm32-adc-core.c | 9 ++++++++-
> 1 file changed, 8 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/iio/adc/stm32-adc-core.c b/drivers/iio/adc/stm32-adc-core.c
> index 0e2068e..3586369 100644
> --- a/drivers/iio/adc/stm32-adc-core.c
> +++ b/drivers/iio/adc/stm32-adc-core.c
> @@ -794,6 +794,13 @@ static int stm32_adc_core_runtime_resume(struct device *dev)
> {
> return stm32_adc_core_hw_start(dev);
> }
> +
> +static int stm32_adc_core_runtime_idle(struct device *dev)
> +{
> + pm_runtime_mark_last_busy(dev);
> +
> + return 0;
> +}
> #endif
>
> static const struct dev_pm_ops stm32_adc_core_pm_ops = {
> @@ -801,7 +808,7 @@ static const struct dev_pm_ops stm32_adc_core_pm_ops = {
> pm_runtime_force_resume)
> SET_RUNTIME_PM_OPS(stm32_adc_core_runtime_suspend,
> stm32_adc_core_runtime_resume,
> - NULL)
> + stm32_adc_core_runtime_idle)
> };
>
> static const struct stm32_adc_priv_cfg stm32f4_adc_priv_cfg = {
>
