Hi, Linus
> On Sun, May 24, 2020 at 4:51 AM Dinghao Liu <dinghao.liu@xxxxxxxxxx> wrote:
>
> > When devm_regmap_init_i2c() returns an error code, a pairing
> > runtime PM usage counter decrement is needed to keep the
> > counter balanced. For error paths after ak8974_set_power(),
> > ak8974_detect() and ak8974_reset(), things are the same.
> >
> > However, When iio_triggered_buffer_setup() returns an error
> > code, we don't need such a decrement because there is already
> > one before this call. Things are the same for other error paths
> > after it.
> >
> > Signed-off-by: Dinghao Liu <dinghao.liu@xxxxxxxxxx>
>
> > ak8974->map = devm_regmap_init_i2c(i2c, &ak8974_regmap_config);
> > if (IS_ERR(ak8974->map)) {
> > dev_err(&i2c->dev, "failed to allocate register map\n");
> > + pm_runtime_put_noidle(&i2c->dev);
> > + pm_runtime_disable(&i2c->dev);
> > return PTR_ERR(ak8974->map);
>
> This is correct.
>
> > ret = ak8974_set_power(ak8974, AK8974_PWR_ON);
> > if (ret) {
> > dev_err(&i2c->dev, "could not power on\n");
> > + pm_runtime_put_noidle(&i2c->dev);
> > + pm_runtime_disable(&i2c->dev);
> > goto power_off;
>
> What about just changing this to goto disable_pm;
>
> > ret = ak8974_detect(ak8974);
> > if (ret) {
> > dev_err(&i2c->dev, "neither AK8974 nor AMI30x found\n");
> > + pm_runtime_put_noidle(&i2c->dev);
> > + pm_runtime_disable(&i2c->dev);
> > goto power_off;
>
> goto disable_pm;
>
> > @@ -786,6 +792,8 @@ static int ak8974_probe(struct i2c_client *i2c,
> > ret = ak8974_reset(ak8974);
> > if (ret) {
> > dev_err(&i2c->dev, "AK8974 reset failed\n");
> > + pm_runtime_put_noidle(&i2c->dev);
> > + pm_runtime_disable(&i2c->dev);
>
> goto disable_pm;
>
> > disable_pm:
> > - pm_runtime_put_noidle(&i2c->dev);
> > pm_runtime_disable(&i2c->dev);
> > ak8974_set_power(ak8974, AK8974_PWR_OFF);
>
> Keep the top pm_runtime_put_noidle().
I found that there was already a pm_runtime_put() before
iio_triggered_buffer_setup() (just after pm_runtime_use_autosuspend).
So if we keep the pm_runtime_put_noidle() here, we will have
two pmusage counter decrement. Do you think this is a bug?
Regards,
Dinghao
>
> The ak8974_set_power() call is fine, the power on call does not
> need to happen in balance. Sure it will attempt to write a register
> but so will the power on call.
>
> Yours,
> Linus Walleij
