On Wed, 11 Mar 2020 10:43:26 +0200 Beniamin Bia <beniamin.bia@xxxxxxxxxx> wrote: > From: Dragos Bogdan <dragos.bogdan@xxxxxxxxxx> > > When CONVST signal is generated internally, IIO_CHAN_INFO_RAW can be > made available for AD7091R for single reads. This patch enables it and > makes supporting more devices by this driver easier. > > Signed-off-by: Dragos Bogdan <dragos.bogdan@xxxxxxxxxx> > Signed-off-by: Beniamin Bia <beniamin.bia@xxxxxxxxxx> Applied. Thanks, Jonathan > --- > drivers/iio/adc/ad7476.c | 11 +++++++++++ > 1 file changed, 11 insertions(+) > > diff --git a/drivers/iio/adc/ad7476.c b/drivers/iio/adc/ad7476.c > index 32e857dfec9c..3b48073dd62d 100644 > --- a/drivers/iio/adc/ad7476.c > +++ b/drivers/iio/adc/ad7476.c > @@ -29,6 +29,8 @@ struct ad7476_state; > struct ad7476_chip_info { > unsigned int int_vref_uv; > struct iio_chan_spec channel[2]; > + /* channels used when convst gpio is defined */ > + struct iio_chan_spec convst_channel[2]; > void (*reset)(struct ad7476_state *); > }; > > @@ -109,6 +111,8 @@ static int ad7476_scan_direct(struct ad7476_state *st) > { > int ret; > > + ad7091_convst(st); > + > ret = spi_sync(st->spi, &st->msg); > if (ret) > return ret; > @@ -176,6 +180,8 @@ static int ad7476_read_raw(struct iio_dev *indio_dev, > #define AD7940_CHAN(bits) _AD7476_CHAN((bits), 15 - (bits), \ > BIT(IIO_CHAN_INFO_RAW)) > #define AD7091R_CHAN(bits) _AD7476_CHAN((bits), 16 - (bits), 0) > +#define AD7091R_CONVST_CHAN(bits) _AD7476_CHAN((bits), 16 - (bits), \ > + BIT(IIO_CHAN_INFO_RAW)) > #define ADS786X_CHAN(bits) _AD7476_CHAN((bits), 12 - (bits), \ > BIT(IIO_CHAN_INFO_RAW)) > > @@ -183,6 +189,8 @@ static const struct ad7476_chip_info ad7476_chip_info_tbl[] = { > [ID_AD7091R] = { > .channel[0] = AD7091R_CHAN(12), > .channel[1] = IIO_CHAN_SOFT_TIMESTAMP(1), > + .convst_channel[0] = AD7091R_CONVST_CHAN(12), > + .convst_channel[1] = IIO_CHAN_SOFT_TIMESTAMP(1), > .reset = ad7091_reset, > }, > [ID_AD7276] = { > @@ -288,6 +296,9 @@ static int ad7476_probe(struct spi_device *spi) > indio_dev->channels = st->chip_info->channel; > indio_dev->num_channels = 2; > indio_dev->info = &ad7476_info; > + > + if (st->convst_gpio && st->chip_info->convst_channel) > + indio_dev->channels = st->chip_info->convst_channel; > /* Setup default message */ > > st->xfer.rx_buf = &st->data;