On Wed, Mar 13, 2019 at 06:39:57PM +0000, Rui Miguel Silva wrote: > Add device tree bindings for the FXAS21002C gyroscope. > > Signed-off-by: Rui Miguel Silva <rui.silva@xxxxxxxxxx> > --- > .../bindings/iio/gyroscope/nxp,fxas21002c.txt | 26 +++++++++++++++++++ > 1 file changed, 26 insertions(+) > create mode 100644 Documentation/devicetree/bindings/iio/gyroscope/nxp,fxas21002c.txt > > diff --git a/Documentation/devicetree/bindings/iio/gyroscope/nxp,fxas21002c.txt b/Documentation/devicetree/bindings/iio/gyroscope/nxp,fxas21002c.txt > new file mode 100644 > index 000000000000..68b4cd283d1d > --- /dev/null > +++ b/Documentation/devicetree/bindings/iio/gyroscope/nxp,fxas21002c.txt > @@ -0,0 +1,26 @@ > +* NXP FXAS21002C Gyroscope device tree bindings > + > +http://www.nxp.com/products/sensors/gyroscopes/3-axis-digital-gyroscope:FXAS21002C > + > +Required properties: > + - compatible : should be "nxp,fxas21002c" > + - reg : the I2C address of the sensor or SPI chip select number for the > + device. > + - vdd-supply: phandle to the regulator that provides power to the sensor. > + - vddio-supply: phandle to the regulator that provides power to the bus. > + > +Optional properties: > + - reset-gpios : gpio used to reset the device, see gpio/gpio.txt > + - interrupts : device support 2 interrupts, INT1 and INT2. > + See interrupt-controller/interrupts.txt Mentioning supported irq flags seems to be fairy common across driver bindings. At least one does not need to scan driver sources to find what is supported. One more thing. Your are using drive-open-drain property. Perhaps it's worth mentioning it in this binding. > + - interrupt-names: should contain "INT1" or "INT2", the gyroscope interrupt > + line in use. > + > +Example: > + > +gyroscope@20 { > + compatible = "nxp,fxas21002c"; > + reg = <0x20>; > + vdd-supply = <®_peri_3p15v>; > + vddio-supply = <®_peri_3p15v>; > +}; > -- > 2.20.1 >
