On Thu, 2018-11-01 at 11:43 -0300, Renato Lui Geh wrote:
> The ad7780 driver previously did not read the correct device output, as
> it read an outdated value set at initialization. It now updates its
> voltage on read.
>
> Signed-off-by: Renato Lui Geh <renatogeh@xxxxxxxxx>
> ---
> Changes in v3:
> - removed initialization (int voltage_uv = 0)
> - returns error when voltage_uv is null
>
> drivers/staging/iio/adc/ad7780.c | 6 +++++-
> 1 file changed, 5 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/staging/iio/adc/ad7780.c
> b/drivers/staging/iio/adc/ad7780.c
> index 91e016d534ed..f2a11e9424cd 100644
> --- a/drivers/staging/iio/adc/ad7780.c
> +++ b/drivers/staging/iio/adc/ad7780.c
> @@ -87,12 +87,16 @@ static int ad7780_read_raw(struct iio_dev *indio_dev,
> long m)
> {
> struct ad7780_state *st = iio_priv(indio_dev);
> + int voltage_uv;
>
> switch (m) {
> case IIO_CHAN_INFO_RAW:
> return ad_sigma_delta_single_conversion(indio_dev, chan,
> val);
> case IIO_CHAN_INFO_SCALE:
> - *val = st->int_vref_mv * st->gain;
> + voltage_uv = regulator_get_voltage(st->reg);
> + if (!voltage_uv)
This looks wrong.
I admit this was done in the same way in the probe function, but that looks
a bit wrong as well.
Typically, the return value of `regulator_get_voltage()` would get checked
with:
ret = regulator_get_voltage(st->reg);
if (ret < 0)
return ret;
*val = ret / 1000;
So, negative values are errors and zero & positive values are valid voltage
values.
> + return -EINVAL;
> + *val = (voltage_uv / 1000) * st->gain;
> *val2 = chan->scan_type.realbits - 1;
> return IIO_VAL_FRACTIONAL_LOG2;
> case IIO_CHAN_INFO_OFFSET:
