Hi Stefan!
On 29.04.2016 17:12, Stefan Wahren wrote:
Hi Harald,
Am 22.04.2016 um 15:52 schrieb Harald Geyer:
Patch 1/3 changes the driver and updates the binding documentation
(I guess it is still in staging.)
Patches 2/3 and 3/3 add the devicetree nodes to imx23 and imx28
boards.
I'd like to get input whether this is actually desired. On boards
where
these regulators would never be enabled this costs a few extra bytes
of
RAM for allocation of the device data, because the nodes can't be
easily
removed in .dts files which are including the .dtsi files. The
alternative
is to add the new nodes to many .dts files, which would be a lot
code
duplication.
if i get it right the real intention of this patch series is to make
the
mxs-lradc provide resistance values instead of voltages.
... or even temperature values if a thermistor is connected.
So how about
dropping the whole regulator stuff and provide the values as
IIO_RESISTANCE via iio interface?
Can you elaborate on this?
My thinking is that there should be a thermistor (or whatever else)
driver,
that is a consumer of the regulator and a consumer of the IIO_VOLTAGE
iio channel and provides a new device with an IIO_RESISTANCE or
IIO_TEMP
channel. Maybe there is a simpler solution, that I'm missing?
Actually I'm not 100% happy with the above solution myself, because if
we
start supporting devices that act as an iio-multiplexer (some device
that
is an iio consumer and provides many new iio channels and can control
via gpios which of it child channels is actually routed to the upstream
device) I don't know how to properly manage the regulator device.
However since this is only hypothetical ATM, I think we don't have to
worry about this too much.
Btw this feature should be only added to dts files where is actually
used.
Ok, so how do we figure out which boards these are?
I use this on the olinuxino and I guess all evaluation boards support
the
use case too. The others I don't know enough about to be sure and I
guess
it's not a good idea to just wait until somebody speaks up and
complains
that the feature is missing on board X ...
Thanks,
Harald
Regards
Stefan
Harald Geyer (3):
iio: mxs-lradc: Add regulators for current sources
ARM: dts: imx23: Provide regulators for the current sources of the
LRADC
ARM: dts: imx28: Provide regulators for the current sources of the
LRADC
.../bindings/staging/iio/adc/mxs-lradc.txt | 29 ++++
arch/arm/boot/dts/imx23.dtsi | 8 ++
arch/arm/boot/dts/imx28.dtsi | 8 ++
drivers/iio/adc/Kconfig | 1 +
drivers/iio/adc/mxs-lradc.c | 152
+++++++++++++++++++++
5 files changed, 198 insertions(+)
--
If you want to support my work:
see http://friends.ccbib.org/harald/supporting/
or donate via peercoin to P98LRdhit3gZbHDBe7ta5jtXrMJUms4p7w
or bitcoin 1FUtd8T9jRN1rFz63vZz7s2fDtB6d6A7aS
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
