Register bits when TSC not in use AFE Pen Ctrl and TouchScreen transistors enabling is not required when only ADC mode is being used, so check for availability of TSC driver before accessing control register. This patch is based on work in the 3.2 tree by TI Original Author is Patil Rachna Signed-off-by: Zubair Lutfullah <zubair.lutfullah@xxxxxxxxx> --- drivers/mfd/ti_am335x_tscadc.c | 18 +++++++++++------- 1 file changed, 11 insertions(+), 7 deletions(-) diff --git a/drivers/mfd/ti_am335x_tscadc.c b/drivers/mfd/ti_am335x_tscadc.c index b003a16..d72001c 100644 --- a/drivers/mfd/ti_am335x_tscadc.c +++ b/drivers/mfd/ti_am335x_tscadc.c @@ -208,13 +208,14 @@ static int ti_tscadc_probe(struct platform_device *pdev) /* Set the control register bits */ ctrl = CNTRLREG_STEPCONFIGWRT | - CNTRLREG_TSCENB | - CNTRLREG_STEPID | - CNTRLREG_4WIRE; + CNTRLREG_STEPID; + if (tsc_wires > 0) + ctrl |= CNTRLREG_4WIRE | CNTRLREG_TSCENB; tscadc_writel(tscadc, REG_CTRL, ctrl); /* Set register bits for Idle Config Mode */ - tscadc_idle_config(tscadc); + if (tsc_wires > 0) + tscadc_idle_config(tscadc); /* Enable the TSC module enable bit */ ctrl = tscadc_readl(tscadc, REG_CTRL); @@ -294,10 +295,13 @@ static int tscadc_resume(struct device *dev) pm_runtime_get_sync(dev); /* context restore */ - ctrl = CNTRLREG_STEPCONFIGWRT | CNTRLREG_TSCENB | - CNTRLREG_STEPID | CNTRLREG_4WIRE; + ctrl = CNTRLREG_STEPCONFIGWRT | CNTRLREG_STEPID; + if (tscadc_dev->tsc_cell != -1) + ctrl |= CNTRLREG_TSCENB | CNTRLREG_4WIRE; tscadc_writel(tscadc_dev, REG_CTRL, ctrl); - tscadc_idle_config(tscadc_dev); + + if (tscadc_dev->tsc_cell != -1) + tscadc_idle_config(tscadc_dev); am335x_tsc_se_update(tscadc_dev); restore = tscadc_readl(tscadc_dev, REG_CTRL); tscadc_writel(tscadc_dev, REG_CTRL, -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-iio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html