Use the new triggered buffer setup helper function to allocate and register
buffer and pollfunc.
Also as part of the conversion drop scan_timestamp being enabled by default,
since it is a left over of an earlier cleanup.
Signed-off-by: Lars-Peter Clausen <lars@xxxxxxxxxx>
---
drivers/staging/iio/adc/Kconfig | 2 +-
drivers/staging/iio/adc/ad799x.h | 2 -
drivers/staging/iio/adc/ad799x_core.c | 25 ++++++++-----
drivers/staging/iio/adc/ad799x_ring.c | 65 ++-------------------------------
4 files changed, 20 insertions(+), 74 deletions(-)
diff --git a/drivers/staging/iio/adc/Kconfig b/drivers/staging/iio/adc/Kconfig
index e3fdb84..67711b7 100644
--- a/drivers/staging/iio/adc/Kconfig
+++ b/drivers/staging/iio/adc/Kconfig
@@ -63,7 +63,7 @@ config AD799X_RING_BUFFER
bool "Analog Devices AD799x: use ring buffer"
depends on AD799X
select IIO_BUFFER
- select IIO_KFIFO_BUF
+ select IIO_TRIGGERED_BUFFER
help
Say yes here to include ring buffer support in the AD799X
ADC driver.
diff --git a/drivers/staging/iio/adc/ad799x.h b/drivers/staging/iio/adc/ad799x.h
index 99f8abe..3e363c4 100644
--- a/drivers/staging/iio/adc/ad799x.h
+++ b/drivers/staging/iio/adc/ad799x.h
@@ -120,8 +120,6 @@ struct ad799x_platform_data {
u16 vref_mv;
};
-int ad7997_8_set_scan_mode(struct ad799x_state *st, unsigned mask);
-
#ifdef CONFIG_AD799X_RING_BUFFER
int ad799x_register_ring_funcs_and_init(struct iio_dev *indio_dev);
void ad799x_ring_cleanup(struct iio_dev *indio_dev);
diff --git a/drivers/staging/iio/adc/ad799x_core.c b/drivers/staging/iio/adc/ad799x_core.c
index 80e0c6e..2d4bda9 100644
--- a/drivers/staging/iio/adc/ad799x_core.c
+++ b/drivers/staging/iio/adc/ad799x_core.c
@@ -99,10 +99,21 @@ static int ad799x_i2c_write8(struct ad799x_state *st, u8 reg, u8 data)
return ret;
}
-int ad7997_8_set_scan_mode(struct ad799x_state *st, unsigned mask)
+static int ad7997_8_update_scan_mode(struct iio_dev *indio_dev,
+ const unsigned long *scan_mask)
{
- return ad799x_i2c_write16(st, AD7998_CONF_REG,
- st->config | (mask << AD799X_CHANNEL_SHIFT));
+ struct ad799x_state *st = iio_priv(indio_dev);
+
+ switch (st->id) {
+ case ad7997:
+ case ad7998:
+ return ad799x_i2c_write16(st, AD7998_CONF_REG,
+ st->config | (*scan_mask << AD799X_CHANNEL_SHIFT));
+ default:
+ break;
+ }
+
+ return 0;
}
static int ad799x_scan_direct(struct ad799x_state *st, unsigned ch)
@@ -442,6 +453,7 @@ static const struct iio_info ad7993_4_7_8_info = {
.read_event_value = &ad799x_read_event_value,
.write_event_value = &ad799x_write_event_value,
.driver_module = THIS_MODULE,
+ .update_scan_mode = ad7997_8_update_scan_mode,
};
#define AD799X_EV_MASK (IIO_EV_BIT(IIO_EV_TYPE_THRESH, IIO_EV_DIR_RISING) | \
@@ -887,12 +899,6 @@ static int __devinit ad799x_probe(struct i2c_client *client,
if (ret)
goto error_disable_reg;
- ret = iio_buffer_register(indio_dev,
- indio_dev->channels,
- indio_dev->num_channels);
- if (ret)
- goto error_cleanup_ring;
-
if (client->irq > 0) {
ret = request_threaded_irq(client->irq,
NULL,
@@ -934,7 +940,6 @@ static __devexit int ad799x_remove(struct i2c_client *client)
if (client->irq > 0)
free_irq(client->irq, indio_dev);
- iio_buffer_unregister(indio_dev);
ad799x_ring_cleanup(indio_dev);
if (!IS_ERR(st->reg)) {
regulator_disable(st->reg);
diff --git a/drivers/staging/iio/adc/ad799x_ring.c b/drivers/staging/iio/adc/ad799x_ring.c
index 1c7ff44..0882c9e 100644
--- a/drivers/staging/iio/adc/ad799x_ring.c
+++ b/drivers/staging/iio/adc/ad799x_ring.c
@@ -18,33 +18,12 @@
#include <linux/iio/iio.h>
#include <linux/iio/buffer.h>
-#include <linux/iio/kfifo_buf.h>
#include <linux/iio/trigger_consumer.h>
+#include <linux/iio/triggered_buffer.h>
#include "ad799x.h"
/**
- * ad799x_ring_preenable() setup the parameters of the ring before enabling
- *
- * The complex nature of the setting of the number of bytes per datum is due
- * to this driver currently ensuring that the timestamp is stored at an 8
- * byte boundary.
- **/
-static int ad799x_ring_preenable(struct iio_dev *indio_dev)
-{
- struct ad799x_state *st = iio_priv(indio_dev);
- /*
- * Need to figure out the current mode based upon the requested
- * scan mask in iio_dev
- */
-
- if (st->id == ad7997 || st->id == ad7998)
- ad7997_8_set_scan_mode(st, *indio_dev->active_scan_mask);
-
- return iio_sw_buffer_preenable(indio_dev);
-}
-
-/**
* ad799x_trigger_handler() bh of trigger launched polling to ring buffer
*
* Currently there is no option in this driver to disable the saving of
@@ -110,49 +89,13 @@ out:
return IRQ_HANDLED;
}
-static const struct iio_buffer_setup_ops ad799x_buf_setup_ops = {
- .preenable = &ad799x_ring_preenable,
- .postenable = &iio_triggered_buffer_postenable,
- .predisable = &iio_triggered_buffer_predisable,
-};
-
int ad799x_register_ring_funcs_and_init(struct iio_dev *indio_dev)
{
- int ret = 0;
-
- indio_dev->buffer = iio_kfifo_allocate(indio_dev);
- if (!indio_dev->buffer) {
- ret = -ENOMEM;
- goto error_ret;
- }
- indio_dev->pollfunc = iio_alloc_pollfunc(NULL,
- &ad799x_trigger_handler,
- IRQF_ONESHOT,
- indio_dev,
- "%s_consumer%d",
- indio_dev->name,
- indio_dev->id);
- if (indio_dev->pollfunc == NULL) {
- ret = -ENOMEM;
- goto error_deallocate_kfifo;
- }
-
- /* Ring buffer functions - here trigger setup related */
- indio_dev->setup_ops = &ad799x_buf_setup_ops;
- indio_dev->buffer->scan_timestamp = true;
-
- /* Flag that polled ring buffering is possible */
- indio_dev->modes |= INDIO_BUFFER_TRIGGERED;
- return 0;
-
-error_deallocate_kfifo:
- iio_kfifo_free(indio_dev->buffer);
-error_ret:
- return ret;
+ return iio_triggered_buffer_setup(indio_dev, NULL,
+ &ad799x_trigger_handler, NULL);
}
void ad799x_ring_cleanup(struct iio_dev *indio_dev)
{
- iio_dealloc_pollfunc(indio_dev->pollfunc);
- iio_kfifo_free(indio_dev->buffer);
+ iio_triggered_buffer_cleanup(indio_dev);
}
--
1.7.10
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
