pci_get_bus_and_slot() is restrictive such that it assumes domain=0 as
where a PCI device is present. This restricts the device drivers to be
reused for other domain numbers.
Getting ready to remove pci_get_bus_and_slot() function in favor of
pci_get_domain_bus_and_slot().
Use pci_get_domain_bus_and_slot() and extract the actual domain number
from the pdev passed in.
Signed-off-by: Sinan Kaya <okaya@xxxxxxxxxxxxxx>
Acked-by: Tejun Heo <tj@xxxxxxxxxx>
---
drivers/ata/pata_ali.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/ata/pata_ali.c b/drivers/ata/pata_ali.c
index d19cd88..0b122f9 100644
--- a/drivers/ata/pata_ali.c
+++ b/drivers/ata/pata_ali.c
@@ -466,7 +466,8 @@ static void ali_init_chipset(struct pci_dev *pdev)
tmp |= 0x01; /* CD_ROM enable for DMA */
pci_write_config_byte(pdev, 0x53, tmp);
}
- north = pci_get_bus_and_slot(0, PCI_DEVFN(0,0));
+ north = pci_get_domain_bus_and_slot(pci_domain_nr(pdev->bus), 0,
+ PCI_DEVFN(0, 0));
if (north && north->vendor == PCI_VENDOR_ID_AL && ali_isa_bridge) {
/* Configure the ALi bridge logic. For non ALi rely on BIOS.
Set the south bridge enable bit */
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
