The IS_ENABLED() macro checks if a Kconfig symbol has been enabled either built-in or as a module, use that macro instead of open coding the same. Signed-off-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx> --- drivers/ata/ahci.c | 2 +- drivers/ata/pata_marvell.c | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c index a83bbcc58b4c..90eabaf81215 100644 --- a/drivers/ata/ahci.c +++ b/drivers/ata/ahci.c @@ -580,7 +580,7 @@ static struct pci_driver ahci_pci_driver = { }, }; -#if defined(CONFIG_PATA_MARVELL) || defined(CONFIG_PATA_MARVELL_MODULE) +#if IS_ENABLED(CONFIG_PATA_MARVELL) static int marvell_enable; #else static int marvell_enable = 1; diff --git a/drivers/ata/pata_marvell.c b/drivers/ata/pata_marvell.c index ae9feb1ba8f7..ff468a6fd8dd 100644 --- a/drivers/ata/pata_marvell.c +++ b/drivers/ata/pata_marvell.c @@ -146,7 +146,7 @@ static int marvell_init_one (struct pci_dev *pdev, const struct pci_device_id *i if (pdev->device == 0x6101) ppi[1] = &ata_dummy_port_info; -#if defined(CONFIG_SATA_AHCI) || defined(CONFIG_SATA_AHCI_MODULE) +#if IS_ENABLED(CONFIG_SATA_AHCI) if (!marvell_pata_active(pdev)) { printk(KERN_INFO DRV_NAME ": PATA port not active, deferring to AHCI driver.\n"); return -ENODEV; -- 2.5.5 -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html