Hi Tejun, On Sat, Oct 17, 2015 at 5:18 PM, <vinayak.kale@xxxxxxxxx> wrote: > From: Vinayak Kale <vinayak.kale@xxxxxxxxxxx> > > This patch is needed to make NCQ commands with FPDMA protocol value > (eg READ/WRITE FPDMA) work over SCSI Generic (SG) interface. > > Signed-off-by: Vinayak Kale <vinayak.kale@xxxxxxxxxxx> > --- > drivers/ata/libata-scsi.c | 10 ++++++++-- > 1 file changed, 8 insertions(+), 2 deletions(-) > > diff --git a/drivers/ata/libata-scsi.c b/drivers/ata/libata-scsi.c > index 0d7f0da..5b0a5ab 100644 > --- a/drivers/ata/libata-scsi.c > +++ b/drivers/ata/libata-scsi.c > @@ -2914,12 +2914,14 @@ ata_scsi_map_proto(u8 byte1) > case 5: /* PIO Data-out */ > return ATA_PROT_PIO; > > + case 12: /* FPDMA */ > + return ATA_PROT_NCQ; > + > case 0: /* Hard Reset */ > case 1: /* SRST */ > case 8: /* Device Diagnostic */ > case 9: /* Device Reset */ > case 7: /* DMA Queued */ > - case 12: /* FPDMA */ > case 15: /* Return Response Info */ > default: /* Reserved */ > break; > @@ -2963,7 +2965,7 @@ static unsigned int ata_scsi_pass_thru(struct ata_queued_cmd *qc) > tf->hob_lbal = cdb[7]; > tf->hob_lbam = cdb[9]; > tf->hob_lbah = cdb[11]; > - tf->flags |= ATA_TFLAG_LBA48; > + tf->flags |= (ATA_TFLAG_LBA48 | ATA_TFLAG_LBA); > } else > tf->flags &= ~ATA_TFLAG_LBA48; > > @@ -2992,6 +2994,10 @@ static unsigned int ata_scsi_pass_thru(struct ata_queued_cmd *qc) > tf->command = cdb[9]; > } > > + /* For NCQ commands with FPDMA protocol, copy the tag value */ > + if (tf->protocol == ATA_PROT_NCQ) > + tf->nsect = qc->tag << 3; > + > /* enforce correct master/slave bit */ > tf->device = dev->devno ? > tf->device | ATA_DEV1 : tf->device & ~ATA_DEV1; > -- > 1.9.1 > Any comments on this? Regards, Vinayak -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html