Re: [PATCH 03/10] ata: at91: use syscon to configure the smc

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Le 16/03/2015 23:44, Alexandre Belloni a écrit :
> Use syscon/regmap to configure the smc. This allows to avoid using
> at91sam9_smc.h and to compile the driver in a multiplatform configuration.
> 
> The driver will still not probe until the proper DT bindings are added.

Alexandre, just for the record, can you describe the DT node that will
match this?
Is it one that will be added to
Documentation/devicetree/bindings/mfd/atmel-smc.txt?

...

> Signed-off-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxxxxxxxxx>
> ---
>  drivers/ata/Kconfig     |  1 -
>  drivers/ata/pata_at91.c | 92 ++++++++++++++++++++++++++++++++++++++-----------
>  2 files changed, 71 insertions(+), 22 deletions(-)
> 
> diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
> index 5f601553b9b0..a3a13605a9c4 100644
> --- a/drivers/ata/Kconfig
> +++ b/drivers/ata/Kconfig
> @@ -835,7 +835,6 @@ config PATA_AT32
>  config PATA_AT91
>  	tristate "PATA support for AT91SAM9260"
>  	depends on ARM && SOC_AT91SAM9
> -	depends on !ARCH_MULTIPLATFORM
>  	help
>  	  This option enables support for IDE devices on the Atmel AT91SAM9260 SoC.
>  
> diff --git a/drivers/ata/pata_at91.c b/drivers/ata/pata_at91.c
> index 9e85937d36a9..ace0a4de3449 100644
> --- a/drivers/ata/pata_at91.c
> +++ b/drivers/ata/pata_at91.c
> @@ -24,11 +24,13 @@
>  #include <linux/ata.h>
>  #include <linux/clk.h>
>  #include <linux/libata.h>
> +#include <linux/mfd/syscon.h>
> +#include <linux/mfd/syscon/atmel-smc.h>
>  #include <linux/platform_device.h>
>  #include <linux/ata_platform.h>
>  #include <linux/platform_data/atmel.h>
> +#include <linux/regmap.h>
>  
> -#include <mach/at91sam9_smc.h>
>  #include <asm/gpio.h>
>  
>  #define DRV_NAME		"pata_at91"
> @@ -57,6 +59,15 @@ struct smc_range {
>  	int max;
>  };
>  
> +struct regmap *smc;
> +
> +struct at91sam9_smc_generic_fields {
> +	struct regmap_field *setup;
> +	struct regmap_field *pulse;
> +	struct regmap_field *cycle;
> +	struct regmap_field *mode;
> +} fields;
> +
>  /**
>   * adjust_smc_value - adjust value for one of SMC registers.
>   * @value: adjusted value
> @@ -206,7 +217,6 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
>  {
>  	int ret = 0;
>  	int use_iordy;
> -	struct sam9_smc_config smc;
>  	unsigned int t6z;         /* data tristate time in ns */
>  	unsigned int cycle;       /* SMC Cycle width in MCK ticks */
>  	unsigned int setup;       /* SMC Setup width in MCK ticks */
> @@ -244,19 +254,21 @@ static void set_smc_timing(struct device *dev, struct ata_device *adev,
>  
>  	dev_dbg(dev, "Use IORDY=%u, TDF Cycles=%u\n", use_iordy, tdf_cycles);
>  
> -	/* SMC Setup Register */
> -	smc.nwe_setup = smc.nrd_setup = setup;
> -	smc.ncs_write_setup = smc.ncs_read_setup = 0;
> -	/* SMC Pulse Register */
> -	smc.nwe_pulse = smc.nrd_pulse = pulse;
> -	smc.ncs_write_pulse = smc.ncs_read_pulse = cs_pulse;
> -	/* SMC Cycle Register */
> -	smc.write_cycle = smc.read_cycle = cycle;
> -	/* SMC Mode Register*/
> -	smc.tdf_cycles = tdf_cycles;
> -	smc.mode = info->mode;
> -
> -	sam9_smc_configure(0, info->cs, &smc);
> +	regmap_fields_write(fields.setup, info->cs,
> +			    AT91SAM9_SMC_NRDSETUP(setup) |
> +			    AT91SAM9_SMC_NWESETUP(setup) |
> +			    AT91SAM9_SMC_NCS_NRDSETUP(0) |
> +			    AT91SAM9_SMC_NCS_WRSETUP(0));
> +	regmap_fields_write(fields.pulse, info->cs,
> +			    AT91SAM9_SMC_NRDPULSE(pulse) |
> +			    AT91SAM9_SMC_NWEPULSE(pulse) |
> +			    AT91SAM9_SMC_NCS_NRDPULSE(cs_pulse) |
> +			    AT91SAM9_SMC_NCS_WRPULSE(cs_pulse));
> +	regmap_fields_write(fields.cycle, info->cs,
> +			    AT91SAM9_SMC_NRDCYCLE(cycle) |
> +			    AT91SAM9_SMC_NWECYCLE(cycle));
> +	regmap_fields_write(fields.mode, info->cs, info->mode |
> +			    AT91_SMC_TDF_(tdf_cycles));
>  }
>  
>  static void pata_at91_set_piomode(struct ata_port *ap, struct ata_device *adev)
> @@ -280,21 +292,21 @@ static unsigned int pata_at91_data_xfer_noirq(struct ata_device *dev,
>  {
>  	struct at91_ide_info *info = dev->link->ap->host->private_data;
>  	unsigned int consumed;
> +	unsigned int mode;
>  	unsigned long flags;
> -	struct sam9_smc_config smc;
>  
>  	local_irq_save(flags);
> -	sam9_smc_read_mode(0, info->cs, &smc);
> +	regmap_fields_read(fields.mode, info->cs, &mode);
>  
>  	/* set 16bit mode before writing data */
> -	smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_16;
> -	sam9_smc_write_mode(0, info->cs, &smc);
> +	regmap_fields_write(fields.mode, info->cs, (mode & ~AT91_SMC_DBW) |
> +			    AT91_SMC_DBW_16);
>  
>  	consumed = ata_sff_data_xfer(dev, buf, buflen, rw);
>  
>  	/* restore 8bit mode after data is written */
> -	smc.mode = (smc.mode & ~AT91_SMC_DBW) | AT91_SMC_DBW_8;
> -	sam9_smc_write_mode(0, info->cs, &smc);
> +	regmap_fields_write(fields.mode, info->cs, (mode & ~AT91_SMC_DBW) |
> +			    AT91_SMC_DBW_8);
>  
>  	local_irq_restore(flags);
>  	return consumed;
> @@ -312,6 +324,36 @@ static struct ata_port_operations pata_at91_port_ops = {
>  	.cable_detect	= ata_cable_40wire,
>  };
>  
> +static int at91sam9_smc_fields_init(struct device *dev)
> +{
> +	struct reg_field field = REG_FIELD(0, 0, 31);
> +
> +	field.id_size = 8;
> +	field.id_offset = AT91SAM9_SMC_GENERIC_BLK_SZ;
> +
> +	field.reg = AT91SAM9_SMC_SETUP(AT91SAM9_SMC_GENERIC);
> +	fields.setup = devm_regmap_field_alloc(dev, smc, field);
> +	if (IS_ERR(fields.setup))
> +		return PTR_ERR(fields.setup);
> +
> +	field.reg = AT91SAM9_SMC_PULSE(AT91SAM9_SMC_GENERIC);
> +	fields.pulse = devm_regmap_field_alloc(dev, smc, field);
> +	if (IS_ERR(fields.pulse))
> +		return PTR_ERR(fields.pulse);
> +
> +	field.reg = AT91SAM9_SMC_CYCLE(AT91SAM9_SMC_GENERIC);
> +	fields.cycle = devm_regmap_field_alloc(dev, smc, field);
> +	if (IS_ERR(fields.cycle))
> +		return PTR_ERR(fields.cycle);
> +
> +	field.reg = AT91SAM9_SMC_MODE(AT91SAM9_SMC_GENERIC);
> +	fields.mode = devm_regmap_field_alloc(dev, smc, field);
> +	if (IS_ERR(fields.mode))
> +		return PTR_ERR(fields.mode);
> +
> +	return 0;
> +}
> +
>  static int pata_at91_probe(struct platform_device *pdev)
>  {
>  	struct at91_cf_data *board = dev_get_platdata(&pdev->dev);
> @@ -341,6 +383,14 @@ static int pata_at91_probe(struct platform_device *pdev)
>  
>  	irq = board->irq_pin;
>  
> +	smc = syscon_regmap_lookup_by_phandle(pdev->dev.of_node, "atmel,smc");

... yes, regarding this string "atmel,smc": what will it match?

Thanks, bye.

> +	if (IS_ERR(smc))
> +		return PTR_ERR(smc);
> +
> +	ret = at91sam9_smc_fields_init(dev);
> +	if (ret < 0)
> +		return ret;
> +
>  	/* init ata host */
>  
>  	host = ata_host_alloc(dev, 1);
> 


-- 
Nicolas Ferre
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux