On 04/16/2013 07:58 PM, Boszormenyi Zoltan wrote:
Hi, The SATA interface can be switched between AHCI and legacy modes as usual: 00:1f.2 SATA controller: Intel Corporation NM10/ICH7 Family SATA Controller [AHCI mode] (rev 02) The device attached to the SATA controller is always a CF card via a SiI3811 Serial ATA to Parallel ATA Device Bridge based converter board.
Can you please attach a normal sata disk and try again with the controller set to AHCI mode? I suspect it may be the SiI3811 bridge that caused this command. Thanks, Aaron -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
