Re: [PATCH v8 08/13] libsas: libsas.force_hard_reset module parameter

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 12-02-29 06:27 PM, Dan Williams wrote:
On Wed, Feb 29, 2012 at 2:40 PM, Douglas Gilbert<dgilbert@xxxxxxxxxxxx>  wrote:
On 12-02-29 04:55 PM, James Bottomley wrote:

On Fri, 2012-02-10 at 00:45 -0800, Dan Williams wrote:

It is possible for a host to get "locked out" from talking to sata
devices in the domain if, for example, its sas address changes but the
expander topology has existing affiliations with the old address.  If
the system is booted userspace can write to
/sys/class/sas_phy/<phy-X>/hard_reset to clear the affiliation, however
if this condition exists for the root device the module parameter can be
used to promote all ata resets to hard resets.


A point of order: SAS has link resets and hard resets. The
hard reset is a superset of link reset. A "link reset sequence
serves as a hard reset for SATA devices" and hence is
sufficient to reset a SATA device. To reset a SAS device
(e.g. a SAS disk) you need a SAS hard reset. Therefore a link
reset is the appropriately sized "gun" to reset a SATA device.

I have a SAS-2 expander that annoyingly powers up with the
programmed maximum physical link rate of its phys at 3 Gbps
even though its hardware maximum rate is 6 Gbps. For expander
phys connected to SAS-2 disks I can up the programmed maximum
value to 6 Gbps on the expander phy then do a link reset on
that phy. So without upsetting Linux (or any other OS) I can
switch that path from 3 Gbps to 6 Gbps. Can't do that with a
SATA disk without the OS finding out.

At least now (with these pending patches) if you trigger a link-reset
via the sysfs interface libsas will manage the link recovery like any
other error-recovery initiated reset.

I can think of 4 cases for link reset. The other end
of the link is:
  a) a SAS target: not error recovery situation
  b) a SAS expander phy: not error recovery situation
  c) a SATA device: error recovery situation
  d) a SAS initiator: not sure, probably not

Doug Gilbert
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux