Re: [RFC PATCH 4/6] PM / Runtime: Introduce flag can_power_off

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, Feb 18, 2012 at 7:54 AM, Rafael J. Wysocki <rjw@xxxxxxx> wrote:
> On Thursday, February 16, 2012, Zhang Rui wrote:
>> On 二, 2012-02-14 at 23:39 +0100, Rafael J. Wysocki wrote:
>> > On Tuesday, February 14, 2012, Zhang Rui wrote:
>> > > On 一, 2012-02-13 at 20:38 +0100, Rafael J. Wysocki wrote:
>> > > > On Monday, February 13, 2012, Alan Stern wrote:
>> > > > > On Mon, 13 Feb 2012, Lin Ming wrote:
[snip]
>> Yeah, I have thought about this for quite a while before, there ARE
>> several ways to do this, but these need a lot of changes in bus code, at
>> least for the buses that support device runtime D3 (off) by ACPI.
>>
>> Lets also take SATA port and ZPODD for example,
>> proposal one,
>> 1) introduce scsi_can_power_off and ata_can_power_off.
>> 2) sr driver set scsi_can_power_off bit and scsi layer is aware of this,
>> thus the scsi host can set this bit as well.
>> 3) in the .runtime_suspend callback of ata port, it knows that its scsi
>> host interface can be powered off, thus it invokes ata_can_power_off to
>> tell the ata layer.
>
> Hmm.  I'm not sure why you want to introduce this special "power off"
> condition.  In fact, it's nothing special, it only means that the device
> in question shouldn't be accessed by software, which pretty much is equivalent
> to the "suspended" condition (as defined in the runtime PM docs).

I think some reasons to introduce can_poweroff can be:

1) To indicate the implementation of .runtime_suspend/.runtime_resume
is compatible with power off.  That is, .runtime_suspend will save all
needed information and .runtime_resume can work on the uninitialized
device.

If this is already the requirement of
.runtime_suspend/.runtime_resume.  Then this is not needed.   Maybe we
can make that explicitly for these callbacks via some kind of
documentation.

2) To support something like pm-qos.  power off device may have more
exit.latency than normal low power state (such as D3Hot).  Some device
may disable can_power_off based on that.

3) Whether to go to power off should be determined by leaf device
(such as SATA disk), but that may be done by its parent device (such
as SATA port).  It's a way for leaf device to tell its parent device
whether it want to go to power off.

[snip]

Best Regards,
Huang Ying
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux