On 01/06/2011 05:30 AM, Andreas Mohr wrote:
Hi,
Robert Hancock wrote:
On 01/05/2011 12:33 PM, Stephen Clark wrote:
Hello,
Why is the kernel limiting me to udma/33 when the device says it can do
ata2.01: CFA: TRANSCEND, 20070831, max UDMA/66
There is no cable the compact flash is a socket on the motherboard!
The kernel has no way to know that, and presumably the board isn't
connecting the signal for IDE pin 34 to ground in order to properly
signal that an 80-wire cable (or equivalent) is connected so that speeds
over UDMA33 can be used.
You should be able to use the libata.force=80c option on the kernel
command line to override the cable detection.
Further comments for the OP:
If 80c happens to be correct for this machine (since it's soldered
it's quite obvious) and the machine is quite wide-spread, perhaps one needs
to add overrides within drivers/ata/pata_via.c/via_cable_detect() functionality,
analogous to the ata_piix.c/ich_pata_cable_detect() case where it uses
an entire ich_laptop device list to match against,
to detect special 80c compatible cases.
But since pata_via.c has the insightful comment
"Perform cable detection. Actually for the VIA case the BIOS
already did this for us."
it looks like your BIOS might be considered "broken"
due to not indicating 80c for such a solder job
--> BIOS upgrade available?
Will check. The machine is an Acrosser AR-M0898B micro box, for use such as
a firewall, vpn appliance, etc.
And perhaps better avoid mentioning a specific kernel in the subject
line unless it's a regression (which likely isn't the case here),
or write it like "..... (on 2.6.XXX)".
Good point.
Andreas Mohr
--
"They that give up essential liberty to obtain temporary safety,
deserve neither liberty nor safety." (Ben Franklin)
"The course of history shows that as a government grows, liberty
decreases." (Thomas Jefferson)
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
