From: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx>
Subject: [PATCH] piix: convert to ide2libata
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx>
---
drivers/ata/ata_piix.h | 15 ++--
drivers/ide/piix.c | 182 ++-----------------------------------------------
2 files changed, 19 insertions(+), 178 deletions(-)
Index: b/drivers/ata/ata_piix.h
===================================================================
--- a/drivers/ata/ata_piix.h
+++ b/drivers/ata/ata_piix.h
@@ -44,7 +44,6 @@ static int ich_short_ata40(struct pci_de
return 0;
}
-#ifdef __LINUX_LIBATA_H__
static DEFINE_SPINLOCK(piix_lock);
static void piix_set_timings(struct ata_port *ap, struct ata_device *adev,
@@ -213,9 +212,18 @@ static void do_pata_set_dmamode(struct a
pci_write_config_byte(dev, 0x48, udma_enable);
spin_unlock_irqrestore(&piix_lock, flags);
- } else
- /* MWDMA is driven by the PIO timings. */
+ } else {
+ /* Normal DMA is driven by the PIO timings. */
+#ifdef __IDE2LIBATA
+ if (speed >= XFER_MW_DMA_0)
+ adev->pio_mode = ata_mwdma_to_pio(speed) + XFER_PIO_0;
+ else
+ adev->pio_mode = XFER_PIO_2; /* for SWDMA2 */
+ piix_set_timings(ap, adev, adev->pio_mode - XFER_PIO_0, 1);
+#else
piix_set_timings(ap, adev, ata_mwdma_to_pio(speed), 1);
+#endif
+ }
}
/**
@@ -268,4 +276,3 @@ static int __devinit piix_check_450nx_er
"A BIOS update may resolve this.\n");
return no_piix_dma;
}
-#endif
Index: b/drivers/ide/piix.c
===================================================================
--- a/drivers/ide/piix.c
+++ b/drivers/ide/piix.c
@@ -55,142 +55,7 @@
#define DRV_NAME "piix"
-static int no_piix_dma;
-
-/**
- * piix_set_pio_mode - set host controller for PIO mode
- * @port: port
- * @drive: drive
- *
- * Set the interface PIO mode based upon the settings done by AMI BIOS.
- */
-
-static void piix_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
-{
- struct pci_dev *dev = to_pci_dev(hwif->dev);
- int is_slave = drive->dn & 1;
- int master_port = hwif->channel ? 0x42 : 0x40;
- int slave_port = 0x44;
- unsigned long flags;
- u16 master_data;
- u8 slave_data;
- static DEFINE_SPINLOCK(tune_lock);
- int control = 0;
- const u8 pio = drive->pio_mode - XFER_PIO_0;
-
- /* ISP RTC */
- static const u8 timings[][2]= {
- { 0, 0 },
- { 0, 0 },
- { 1, 0 },
- { 2, 1 },
- { 2, 3 }, };
-
- /*
- * Master vs slave is synchronized above us but the slave register is
- * shared by the two hwifs so the corner case of two slave timeouts in
- * parallel must be locked.
- */
- spin_lock_irqsave(&tune_lock, flags);
- pci_read_config_word(dev, master_port, &master_data);
-
- if (pio > 1)
- control |= 1; /* Programmable timing on */
- if (drive->media == ide_disk)
- control |= 4; /* Prefetch, post write */
- if (ide_pio_need_iordy(drive, pio))
- control |= 2; /* IORDY */
- if (is_slave) {
- master_data |= 0x4000;
- master_data &= ~0x0070;
- /* Set PPE, IE and TIME */
- master_data |= control << 4;
- pci_read_config_byte(dev, slave_port, &slave_data);
- slave_data &= hwif->channel ? 0x0f : 0xf0;
- slave_data |= ((timings[pio][0] << 2) | timings[pio][1]) <<
- (hwif->channel ? 4 : 0);
- } else {
- master_data &= ~0x3307;
- /* enable PPE, IE and TIME */
- master_data |= control;
- master_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8);
- }
- pci_write_config_word(dev, master_port, master_data);
- if (is_slave)
- pci_write_config_byte(dev, slave_port, slave_data);
- spin_unlock_irqrestore(&tune_lock, flags);
-}
-
-/**
- * piix_set_dma_mode - set host controller for DMA mode
- * @hwif: port
- * @drive: drive
- *
- * Set a PIIX host controller to the desired DMA mode. This involves
- * programming the right timing data into the PCI configuration space.
- */
-
-static void piix_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive)
-{
- struct pci_dev *dev = to_pci_dev(hwif->dev);
- u8 maslave = hwif->channel ? 0x42 : 0x40;
- int a_speed = 3 << (drive->dn * 4);
- int u_flag = 1 << drive->dn;
- int v_flag = 0x01 << drive->dn;
- int w_flag = 0x10 << drive->dn;
- int u_speed = 0;
- int sitre;
- u16 reg4042, reg4a;
- u8 reg48, reg54, reg55;
- const u8 speed = drive->dma_mode;
-
- pci_read_config_word(dev, maslave, ®4042);
- sitre = (reg4042 & 0x4000) ? 1 : 0;
- pci_read_config_byte(dev, 0x48, ®48);
- pci_read_config_word(dev, 0x4a, ®4a);
- pci_read_config_byte(dev, 0x54, ®54);
- pci_read_config_byte(dev, 0x55, ®55);
-
- if (speed >= XFER_UDMA_0) {
- u8 udma = speed - XFER_UDMA_0;
-
- u_speed = min_t(u8, 2 - (udma & 1), udma) << (drive->dn * 4);
-
- if (!(reg48 & u_flag))
- pci_write_config_byte(dev, 0x48, reg48 | u_flag);
- if (speed == XFER_UDMA_5) {
- pci_write_config_byte(dev, 0x55, (u8) reg55|w_flag);
- } else {
- pci_write_config_byte(dev, 0x55, (u8) reg55 & ~w_flag);
- }
- if ((reg4a & a_speed) != u_speed)
- pci_write_config_word(dev, 0x4a, (reg4a & ~a_speed) | u_speed);
- if (speed > XFER_UDMA_2) {
- if (!(reg54 & v_flag))
- pci_write_config_byte(dev, 0x54, reg54 | v_flag);
- } else
- pci_write_config_byte(dev, 0x54, reg54 & ~v_flag);
- } else {
- const u8 mwdma_to_pio[] = { 0, 3, 4 };
-
- if (reg48 & u_flag)
- pci_write_config_byte(dev, 0x48, reg48 & ~u_flag);
- if (reg4a & a_speed)
- pci_write_config_word(dev, 0x4a, reg4a & ~a_speed);
- if (reg54 & v_flag)
- pci_write_config_byte(dev, 0x54, reg54 & ~v_flag);
- if (reg55 & w_flag)
- pci_write_config_byte(dev, 0x55, (u8) reg55 & ~w_flag);
-
- if (speed >= XFER_MW_DMA_0)
- drive->pio_mode =
- mwdma_to_pio[speed - XFER_MW_DMA_0] + XFER_PIO_0;
- else
- drive->pio_mode = XFER_PIO_2; /* for SWDMA2 */
-
- piix_set_pio_mode(hwif, drive);
- }
-}
+static int piix_no_dma;
/**
* init_chipset_ich - set up the ICH chipset
@@ -237,6 +102,7 @@ static void ich_clear_irq(ide_drive_t *d
outb(dma_stat, hwif->dma_base + ATA_DMA_STATUS);
}
+#include <linux/ide2libata.h>
#include "../ata/ata_piix.h"
static int piix_cable_detect(ide_hwif_t *hwif)
@@ -263,22 +129,19 @@ static int piix_cable_detect(ide_hwif_t
static void __devinit init_hwif_piix(ide_hwif_t *hwif)
{
- if (!hwif->dma_base)
- return;
-
- if (no_piix_dma)
+ if (hwif->dma_base && piix_no_dma)
hwif->ultra_mask = hwif->mwdma_mask = hwif->swdma_mask = 0;
}
static const struct ide_port_ops piix_port_ops = {
- .set_pio_mode = piix_set_pio_mode,
- .set_dma_mode = piix_set_dma_mode,
+ .set_pio_mode = piix_set_piomode,
+ .set_dma_mode = ich_set_dmamode, /* FIXME: needs more work */
.cable_detect = piix_cable_detect,
};
static const struct ide_port_ops ich_port_ops = {
- .set_pio_mode = piix_set_pio_mode,
- .set_dma_mode = piix_set_dma_mode,
+ .set_pio_mode = piix_set_piomode,
+ .set_dma_mode = ich_set_dmamode,
.clear_irq = ich_clear_irq,
.cable_detect = piix_cable_detect,
};
@@ -346,38 +209,10 @@ static const struct ide_port_info piix_p
static int __devinit piix_init_one(struct pci_dev *dev, const struct pci_device_id *id)
{
+ piix_no_dma = piix_check_450nx_errata(dev);
return ide_pci_init_one(dev, &piix_pci_info[id->driver_data], NULL);
}
-/**
- * piix_check_450nx - Check for problem 450NX setup
- *
- * Check for the present of 450NX errata #19 and errata #25. If
- * they are found, disable use of DMA IDE
- */
-
-static void __devinit piix_check_450nx(void)
-{
- struct pci_dev *pdev = NULL;
- u16 cfg;
- while((pdev=pci_get_device(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82454NX, pdev))!=NULL)
- {
- /* Look for 450NX PXB. Check for problem configurations
- A PCI quirk checks bit 6 already */
- pci_read_config_word(pdev, 0x41, &cfg);
- /* Only on the original revision: IDE DMA can hang */
- if (pdev->revision == 0x00)
- no_piix_dma = 1;
- /* On all revisions below 5 PXB bus lock must be disabled for IDE */
- else if (cfg & (1<<14) && pdev->revision < 5)
- no_piix_dma = 2;
- }
- if(no_piix_dma)
- printk(KERN_WARNING DRV_NAME ": 450NX errata present, disabling IDE DMA.\n");
- if(no_piix_dma == 2)
- printk(KERN_WARNING DRV_NAME ": A BIOS update may resolve this.\n");
-}
-
static const struct pci_device_id piix_pci_tbl[] = {
{ PCI_VDEVICE(INTEL, PCI_DEVICE_ID_INTEL_82371FB_0), 1 },
{ PCI_VDEVICE(INTEL, PCI_DEVICE_ID_INTEL_82371FB_1), 1 },
@@ -421,7 +256,6 @@ static struct pci_driver piix_pci_driver
static int __init piix_ide_init(void)
{
- piix_check_450nx();
return ide_pci_register_driver(&piix_pci_driver);
}
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
