On a Compaq Presario V3000 laptop (NVIDIA MCP51 chipset), pata_amd selects PIO0 mode for the PATA DVD-RAM drive instead of MWDMA2 which it supports: ata4.00: ATAPI: HL-DT-ST DVDRAM GSA-4084N, KQ09, max MWDMA2 ata4: nv_mode_filter: 0x39f&0x7001->0x1, BIOS=0x0 (0x0) ACPI=0x7001 (60:600:0x11) ata4.00: configured for PIO0 For some reason, the BIOS-set UDMA configuration returns 0 and the ACPI _GTM reports that UDMA2 and PIO0 are enabled. This causes nv_mode_filter to end up allowing only PIO0 and UDMA0-2. Since the drive doesn't support UDMA we end up using PIO0. Since the controllers should always support PIO4, MWDMA2 and UDMA2 regardless of what cable type is used, let's make sure we don't filter out these modes regardless of what wacky settings the BIOS is using. Signed-off-by: Robert Hancock <hancockrwd@xxxxxxxxx> Cc: stable@xxxxxxxxxx diff --git a/drivers/ata/pata_amd.c b/drivers/ata/pata_amd.c index 33a74f1..567f3f7 100644 --- a/drivers/ata/pata_amd.c +++ b/drivers/ata/pata_amd.c @@ -307,6 +307,9 @@ static unsigned long nv_mode_filter(struct ata_device *dev, limit |= ATA_MASK_PIO; if (!(limit & (ATA_MASK_MWDMA | ATA_MASK_UDMA))) limit |= ATA_MASK_MWDMA | ATA_MASK_UDMA; + /* PIO4, MWDMA2, UDMA2 should always be supported regardless of + cable detection result */ + limit |= ata_pack_xfermask(ATA_PIO4, ATA_MWDMA2, ATA_UDMA2); ata_port_printk(ap, KERN_DEBUG, "nv_mode_filter: 0x%lx&0x%lx->0x%lx, " "BIOS=0x%lx (0x%x) ACPI=0x%lx%s\n", -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
