On 07/23/2009 04:31 PM, Greg Freemyer wrote:
cc'ing: linux-ide@xxxxxxxxxxxxxxx
maybe they can help
On Thu, Jul 23, 2009 at 6:12 PM, Bill Weiler<weilerb@xxxxxxxxxxx> wrote:
________________________________________
From: Greg Freemyer [greg.freemyer@xxxxxxxxx]
Sent: Thursday, July 23, 2009 2:31 PM
To: Bill Weiler
Cc: Kernelnewbies
Subject: Re: Drive tester
On Wed, Jul 22, 2009 at 7:55 PM, Bill Weiler<weilerb@xxxxxxxxxxx> wrote:
I wanted to make an Application that could send scripted SCSI and SATA
commands to my drives. I have found my Fedora Linux to be too complex to
control the drives in this way. I have looked at minimal Linux but I think
this would have the same problem. Is there an easier Open Source OS, or an
embedded PC Linux that would be easier to modify?
Bill,
For sata drives, have you looked at the SG_IO interface?
That is how hdparm interfaces with the kernel. I know it sends a lot
of low level ATA commands to the drive from user space. I think most
use the SG_IO interface. How much simpler can it get?
strace hdparm may give you an education as to how simple it is.
The best way to issue arbitrary ATA commands is likely to issue them as
ATA pass-through SCSI commands using SG_IO, yes.
fyi: I believe the kernel looks for dangerous ata commands and blocks
them. But I think those are the types of commands that cause data
loss. Not sure what the criteria is.
If you're running as unprivileged user I believe we block things like
could do things like brick the drive such as uploading firmware, etc.
However, if you have read-write access to the device node you can still
read and write sectors anywhere on the disk. A few commands are blocked
even for root users, like SET FEATURES - XFER MODE as it will screw up
the mode configuration, but it's mostly fair game.
I have studied hdparm and the SG_IO interface and delved into the scsi drivers and ata drivers.
For example, I wanted to script a single NCQ and a single NCQ write. A normal read(fd,buf,4096) does 1 NCQ read but a write(fd,buf,4096) does dozens of NCQ reads before doing the 1 NCQ write. How do I get rid of these reads?
Try opening the device node with O_DIRECT. That will prevent pagecache
effects from changing the IO pattern. However, you can't get less than
page-size (4K granularity) on requests, for that you'll need to issue
SCSI or ATA commands directly.
Also, I need to do soft and hard resets and these are not exposed.
Indeed, there's no way currently to trigger these other than as part of
error handling (i.e. command errors, hotplug operations, etc.) There's
likely no reason it couldn't be added, but obviously nobody's needed it
enough to bother so far..
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
