On Sat, May 09, 2009 at 10:50:08AM +0200, Borislav Petkov wrote:
> On Sat, May 09, 2009 at 10:02:45AM +0200, Sam Ravnborg wrote:
> > On Sat, May 09, 2009 at 09:45:21AM +0200, Borislav Petkov wrote:
> > > ide-tape had a potential bug for fs requests when preparing the command
> > > packet: it was writing the transfer length as a number of fixed blocks.
> > > However, the block layer implies 512 byte blocks and ide-tape can have
> > > other block sizes so account for that too.
> > >
> > > ide-floppy does this calculation properly with the block size factor
> > > (floppy->bs_factor).
> > >
> > > Signed-off-by: Borislav Petkov <petkovbb@xxxxxxxxx>
> > > ---
> > > drivers/ide/ide-tape.c | 2 +-
> > > 1 files changed, 1 insertions(+), 1 deletions(-)
> > >
> > > diff --git a/drivers/ide/ide-tape.c b/drivers/ide/ide-tape.c
> > > index e166045..fc79cf4 100644
> > > --- a/drivers/ide/ide-tape.c
> > > +++ b/drivers/ide/ide-tape.c
> > > @@ -586,7 +586,7 @@ static void ide_tape_create_rw_cmd(idetape_tape_t *tape,
> > > struct ide_atapi_pc *pc, struct request *rq,
> > > u8 opcode)
> > > {
> > > - unsigned int length = blk_rq_sectors(rq);
> > > + unsigned int length = blk_rq_sectors(rq) / (tape->blk_size >> 9);
> >
> > If tape->blk_size equals 256 or less then we get a divide-by-zero.
>
> Yes, there is a far-fetched, potential possibility for that but here's
> what the QIC 157D (http://www.qic.org/html/standards/15x.x/qic157d.pdf)
> spec for streaming tapes says on block sizes:
>
> "The Block Length specifies the current length in bytes of each logical
> block described by the block descriptor for the current medium. For QIC
> Streaming Tape Devices, two block sizes supported may be of either 512
> or 1024 bytes per block."
>
> Also, the driver catches invalid block sizes in
> idetape_get_mode_sense_results() so I guess we should be fine.
OK - but If I am wondering maybe the next reader will
think the same
A small comment:
/* idetape_get_mode_sense_results() prevent sizes less than 1 << 9 */
Seems to be reasonable.
Sam
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
