Mark Lord wrote:
Jeff Garzik wrote:
Currently, libata creates a Scsi_Host per port. This was originally
done to leverage SCSI's infrastructure to arbitrate among master/slave
devices, but is not needed for most modern SATA controllers. And I
_think_ it is not needed for master/slave if done properly, either.
The patch below converts libata such that there is now a 1:1
correspondence between struct Scsi_Host and struct ata_host. ATA ports
are represented as SCSI layer 'channels', which is more natural.
This patch is an experiment, and not meant for upstream anytime soon.
..
Could you perhaps explain how error handling would behave in this scheme?
Currently, one SATA port can have failures without any impact whatsoever
on concurrent operation of other ports, in part because each port is
treated
as a completely independent SCSI host.
I wonder if that changes with the new (better) scheme proposed here?
It changes, yes, most definitely. We just have to pay close attention,
and make sure to indicate which EH actions are host-wide, channel-wide
(== per port, in ATA parlance) or per-device.
SCSI handles all these cases, because e.g. you might not want to disrupt
all 1,000 SAN devices actively talking to a single SCSI host in Linux.
So... error handling should behave how it needs to behave ;-)
There might be an issue with concurrent error handling, because of
potential sharing of EH threads (== one port's EH must wait for
another's, I think)....but not with concurrent and independent
operation. You should be able to reset an AHCI port without affecting
data xfer on the other ports.
Jeff
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
