Re: SB600 in AHCI mode will not run SATA optical drive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Robert Hancock wrote:

> Could be some kind of SATA PHY quirk or incompatibility that only shows
> up in AHCI mode or something. It seems from the output that the SATA
> link may be going up and down. You could try forcing 1.5Gbps
> (libata.force=1.5Gbps if libata is built in, or force=1.5Gbps when the
> libata module gets loaded) and see if that helps.

That appears to have done it--thanks!  I feel kinda bad now because I was
suspecting a speed issue, but couldn't figure out how to force it.  If I
had read the kernel documentation a little more, I would have found the
kernel option you mentioned.  Duh.  At any rate, thanks again.



--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux