Re: ATA Bus Error with ICH7R and WDC WD7500AAKS-0

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Andrew Morton wrote:
(cc linux-ide)

On Wed, 02 Apr 2008 18:51:05 +0530
Chaitanya Huilgol <chaitanya@xxxxxxxxxxxxx> wrote:

Hi,

I am getting frequent 'ATA bus error' with ICH7R & WD7500AAKS-0.
I have tried the following combinations of NCQ and Write Cache disabled,
Write I/O is done with dd:
dd if=/dev/zero of=/dev/sdc bs=1048576

(1) With Write Cache is Disabled and NCQ is enabled then the
errors are seen immediately on starting I/O
(2) With Write Cache enabled and NCQ enabled the errors are less frequent
(3) With NCQ disabled using "echo 1 >/sys/block/sdc/device/queue_depth"
the errors are rare but do occur.

I have tried with different SATA Cables & Sata port combinations to
rule out cable/bad port issues.

I am wondering if the WDC WD7500AAKS-0 is another candidate for NCQ blacklist?

PHY RDY changed is likely to indicate hardware problems. Especially so on ICH ahci's which is one of the best supported and tested. Can you please re-seat cable and move the harddrive to different power connector?

--
tejun
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux