* proc_reports_siimage() is now only called by init_chipset_siimage()
so inline it there.
* Use array instead of switch statement for reporting clock modes.
There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx>
---
drivers/ide/pci/siimage.c | 33 ++++++++-------------------------
1 file changed, 8 insertions(+), 25 deletions(-)
Index: b/drivers/ide/pci/siimage.c
===================================================================
--- a/drivers/ide/pci/siimage.c
+++ b/drivers/ide/pci/siimage.c
@@ -440,30 +440,6 @@ static void sil_sata_pre_reset(ide_drive
}
/**
- * proc_reports_siimage - add siimage controller to proc
- * @dev: PCI device
- * @clocking: SCSC value
- * @name: controller name
- *
- * Report the clocking mode of the controller and add it to
- * the /proc interface layer
- */
-
-static void proc_reports_siimage (struct pci_dev *dev, u8 clocking, const char *name)
-{
- if (!pdev_is_sata(dev)) {
- printk(KERN_INFO "%s: BASE CLOCK ", name);
- clocking &= 0x03;
- switch (clocking) {
- case 0x03: printk("DISABLED!\n"); break;
- case 0x02: printk("== 2X PCI\n"); break;
- case 0x01: printk("== 133\n"); break;
- case 0x00: printk("== 100\n"); break;
- }
- }
-}
-
-/**
* setup_mmio_siimage - switch an SI controller into MMIO
* @dev: PCI device we are configuring
* @name: device name
@@ -585,7 +561,14 @@ static unsigned int __devinit init_chips
writel(0x00680000, ioaddr + 0x1C8);
}
- proc_reports_siimage(dev, tmp >> 4, name);
+ /* report the clocking mode of the controller */
+ if (!pdev_is_sata(dev)) {
+ static const char *clk_str[] =
+ { "== 100", "== 133", "== 2X PCI", "DISABLED!" };
+
+ tmp >>= 4;
+ printk(KERN_INFO "%s: BASE CLOCK %s\n", name, clk_str[tmp & 3]);
+ }
return 0;
}
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
