* "hdx=cyls,heads,sects,wpcom,irq" should be "hdx=cyls,heads,sects". * "hdx=" is for "x" from 'a' to 'u', "idex=" is for "x" from '0' to '9'. * "idex=noautotune" is long gone. * Obsoleted "ide0=" parameters were already removed from the documentation. Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx> --- goes after "ide: mark special "ide0=" kernel parameters as obsoleted" patch Documentation/ide/ide.txt | 12 +++--------- 1 file changed, 3 insertions(+), 9 deletions(-) Index: b/Documentation/ide/ide.txt =================================================================== --- a/Documentation/ide/ide.txt +++ b/Documentation/ide/ide.txt @@ -105,7 +105,7 @@ Drives are normally found by auto-probin For really weird situations, the apparent (fdisk) geometry can also be specified on the kernel "command line" using LILO. The format of such lines is: - hdx=cyls,heads,sects,wpcom,irq + hdx=cyls,heads,sects or hdx=cdrom where hdx can be any of hda through hdh, Three values are required @@ -214,9 +214,9 @@ driver using the "options=" keyword to i Summary of ide driver parameters for kernel command line -------------------------------------------------------- - "hdx=" is recognized for all "x" from "a" to "h", such as "hdc". + "hdx=" is recognized for all "x" from "a" to "u", such as "hdc". - "idex=" is recognized for all "x" from "0" to "3", such as "ide1". + "idex=" is recognized for all "x" from "0" to "9", such as "ide1". "hdx=noprobe" : drive may be present, but do not probe for it @@ -233,8 +233,6 @@ Summary of ide driver parameters for ker "hdx=remap63" : remap the drive: add 63 to all sector numbers (for DM OnTrack) - "idex=noautotune" : driver will NOT attempt to tune interface speed - "hdx=autotune" : driver will attempt to tune interface speed to the fastest PIO mode supported, if possible for this drive only. @@ -282,10 +280,6 @@ Summary of ide driver parameters for ker "ide=reverse" : formerly called to pci sub-system, but now local. -The following are valid ONLY on ide0, which usually corresponds -to the first ATA interface found on the particular host, and the defaults for -the base,ctl ports must not be altered. - "ide=doubler" : probe/support IDE doublers on Amiga There may be more options than shown -- use the source, Luke! -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
