Gene Heskett wrote:
Greeting; I had to reboot early this morning due to a freezeup, and I had a bunch of these in the messages log: ============== Jan 27 19:42:11 coyote kernel: [42461.915961] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x2 frozen Jan 27 19:42:11 coyote kernel: [42461.915973] ata1.00: cmd ca/00:08:b1:66:46/00:00:00:00:00/e8 tag 0 dma 4096 out Jan 27 19:42:11 coyote kernel: [42461.915974] res 40/00:01:00:4f:c2/00:00:00:00:00/00 Emask 0x4 (timeout) Jan 27 19:42:11 coyote kernel: [42461.915978] ata1.00: status: { DRDY } Jan 27 19:42:11 coyote kernel: [42461.916005] ata1: soft resetting link Jan 27 19:42:12 coyote kernel: [42462.078216] ata1.00: configured for UDMA/100 Jan 27 19:42:12 coyote kernel: [42462.078232] ata1: EH complete Jan 27 19:42:12 coyote kernel: [42462.090700] sd 0:0:0:0: [sda] 390721968 512-byte hardware sectors (200050 MB) Jan 27 19:42:12 coyote kernel: [42462.114230] sd 0:0:0:0: [sda] Write Protect is off Jan 27 19:42:12 coyote kernel: [42462.115079] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA =============== That one showed up about 2 hours ago, so I expect I'll be locked up again before I've managed a 24 hour uptime. This drive passed a 'smartctl -t long /dev/sda' with flying colors after the reboot this morning. Two instances were logged after I had rebooted to 2.6.24 from 2.6.24-rc8: Jan 24 20:46:33 coyote kernel: [ 0.000000] Linux version 2.6.24 (root@xxxxxxxxxxxxxxxxx) (gcc version 4.1.2 20070925 (Red Hat 4.1.2-33)) #1 SMP Thu Jan 24 20:17:55 EST 2008 ---- Jan 27 02:28:29 coyote kernel: [193207.445158] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x2 frozen Jan 27 02:28:29 coyote kernel: [193207.445170] ata1.00: cmd 35/00:08:f9:24:0a/00:00:17:00:00/e0 tag 0 dma 4096 out Jan 27 02:28:29 coyote kernel: [193207.445172] res 40/00:01:00:4f:c2/00:00:00:00:00/00 Emask 0x4 (timeout) Jan 27 02:28:29 coyote kernel: [193207.445175] ata1.00: status: { DRDY } Jan 27 02:28:29 coyote kernel: [193207.445202] ata1: soft resetting link Jan 27 02:28:29 coyote kernel: [193207.607384] ata1.00: configured for UDMA/100 Jan 27 02:28:29 coyote kernel: [193207.607399] ata1: EH complete Jan 27 02:28:29 coyote kernel: [193207.609681] sd 0:0:0:0: [sda] 390721968 512-byte hardware sectors (200050 MB) Jan 27 02:28:29 coyote kernel: [193207.619277] sd 0:0:0:0: [sda] Write Protect is off Jan 27 02:28:29 coyote kernel: [193207.649041] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA Jan 27 02:30:06 coyote kernel: [193304.336929] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x2 frozen Jan 27 02:30:06 coyote kernel: [193304.336940] ata1.00: cmd ca/00:20:69:22:a6/00:00:00:00:00/e7 tag 0 dma 16384 out Jan 27 02:30:06 coyote kernel: [193304.336942] res 40/00:01:00:4f:c2/00:00:00:00:00/00 Emask 0x4 (timeout) Jan 27 02:30:06 coyote kernel: [193304.336945] ata1.00: status: { DRDY } Jan 27 02:30:06 coyote kernel: [193304.336972] ata1: soft resetting link Jan 27 02:30:06 coyote kernel: [193304.499210] ata1.00: configured for UDMA/100 Jan 27 02:30:06 coyote kernel: [193304.499226] ata1: EH complete Jan 27 02:30:06 coyote kernel: [193304.499714] sd 0:0:0:0: [sda] 390721968 512-byte hardware sectors (200050 MB) Jan 27 02:30:06 coyote kernel: [193304.499857] sd 0:0:0:0: [sda] Write Protect is off Jan 27 02:30:06 coyote kernel: [193304.502315] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA None were logged during the time I was running an -rc7 or -rc8. The previous hits on this resulted in the udma speed being downgraded till it was actually running in pio just before the freeze that required the hardware reset button. I'll reboot to -rc8 right now and resume. If its the drive, I should see it. If not, then 2.6.24 is where I'll point the finger.
.. The only libata change I can see that could possibly affect your setup, is this one here, which went in sometime between -rc7 and -final: --- linux-2.6.24-rc7/drivers/ata/libata-eh.c 2008-01-06 16:45:38.000000000 -0500 +++ linux-2.6.24/drivers/ata/libata-eh.c 2008-01-24 17:58:37.000000000 -0500 @@ -1733,11 +1733,15 @@ ehc->i.action &= ~ATA_EH_PERDEV_MASK; } - /* consider speeding down */ + /* propagate timeout to host link */ + if ((all_err_mask & AC_ERR_TIMEOUT) && !ata_is_host_link(link)) + ap->link.eh_context.i.err_mask |= AC_ERR_TIMEOUT; + It looks pretty innocent to me, though. If you want to try reverting just that change (comment out the two lines and rebuild), then that might provide useful information here. If -final is still b0rked even with those two lines changed back, then I suspect you're just "getting lucky" when switching between the -rc7/-rc8 kernel and the -final kernel. "Lucky" in a bad way, that is. The real test would be to rebuild the kernel without libata, and *with* the old IDE driver instead, and see if the problems persist. If you need help with that, then perhaps someone familiar with Fedora might be able to assist. Cheers - To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html