Hello! I'm running 2.6.24-rc7 with an Addonics AD4CFPRJ Quad-CF PCI Controller (http://www.addonics.com/products/flash_memory_reader/ad4cfprj.asp) using Silicon Image PCI0680 chipset which is connected direct (no cables) with 2 Compact-Flash Cards. In configured CONFIG_ATA=y CONFIG_PATA_SIL680=y and the controller is correclty found, but it complains about 40-wire cables, but I'm not using any cables at all. Is there a solution to disable this check or to correct this? Regards Tobias dmesg reports [ 32.577206] pata_sil680 0000:03:04.0: version 0.4.8 [ 32.577230] sil680: 133MHz clock. [ 32.577302] ACPI: PCI Interrupt 0000:03:04.0[A] -> GSI 16 (level, low) -> IRQ 16 [ 32.577986] PCI: Setting latency timer of device 0000:03:04.0 to 64 [ 32.578062] scsi4 : pata_sil680 [ 32.578232] scsi5 : pata_sil680 [ 32.578337] ata5: PATA max UDMA/133 irq 16 [ 32.578399] ata6: PATA max UDMA/133 irq 16 [ 32.732289] ata5.00: ATA-4: SanDisk SDCFX4-8192, HDX 4.20, max UDMA/66 [ 32.732353] ata5.00: 16007040 sectors, multi 0: LBA [ 32.732422] ata5.00: limited to UDMA/33 due to 40-wire cable [ 32.733155] ata5.00: configured for UDMA/33 [ 32.892034] ata6.00: ATA-4: SanDisk SDCFX3-2048, HDX 4.08, max MWDMA2 [ 32.892099] ata6.00: 4001760 sectors, multi 0: LBA [ 32.911705] ata6.00: configured for MWDMA2 [ 32.911856] scsi 4:0:0:0: Direct-Access ATA SanDisk SDCFX4-8 HDX PQ: 0 ANSI: 5 [ 32.912062] sd 4:0:0:0: [sdc] 16007040 512-byte hardware sectors (8196 MB) [ 32.912135] sd 4:0:0:0: [sdc] Write Protect is off [ 32.912198] sd 4:0:0:0: [sdc] Mode Sense: 00 3a 00 00 [ 32.912215] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 32.912357] sd 4:0:0:0: [sdc] 16007040 512-byte hardware sectors (8196 MB) [ 32.912429] sd 4:0:0:0: [sdc] Write Protect is off [ 32.912492] sd 4:0:0:0: [sdc] Mode Sense: 00 3a 00 00 [ 32.912508] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 32.912604] sdc: sdc1 sdc2 [ 32.913353] sd 4:0:0:0: [sdc] Attached SCSI disk [ 32.913554] scsi 5:0:0:0: Direct-Access ATA SanDisk SDCFX3-2 HDX PQ: 0 ANSI: 5 [ 32.913746] sd 5:0:0:0: [sdd] 4001760 512-byte hardware sectors (2049 MB) [ 32.913819] sd 5:0:0:0: [sdd] Write Protect is off [ 32.913882] sd 5:0:0:0: [sdd] Mode Sense: 00 3a 00 00 [ 32.913898] sd 5:0:0:0: [sdd] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 32.914026] sd 5:0:0:0: [sdd] 4001760 512-byte hardware sectors (2049 MB) [ 32.914099] sd 5:0:0:0: [sdd] Write Protect is off [ 32.914161] sd 5:0:0:0: [sdd] Mode Sense: 00 3a 00 00 [ 32.914176] sd 5:0:0:0: [sdd] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 32.914273] sdd: sdd1 [ 32.915200] sd 5:0:0:0: [sdd] Attached SCSI dis lspci -v 03:04.0 RAID bus controller: Silicon Image, Inc. PCI0680 Ultra ATA-133 Host Controller (rev 02) Subsystem: Silicon Image, Inc. Winic W-680 (Silicon Image 680 based) Flags: bus master, medium devsel, latency 64, IRQ 16 I/O ports at df00 [size=8] I/O ports at de00 [size=4] I/O ports at dd00 [size=8] I/O ports at dc00 [size=4] I/O ports at db00 [size=16] Memory at fdcff000 (32-bit, non-prefetchable) [size=256] [virtual] Expansion ROM at fdb00000 [disabled] [size=512K] Capabilities: [60] Power Management version 2 Kernel driver in use: pata_sil680 - To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
